| auszookers.com https://auszookers.com/forum/ |
|
| Vit Brakes to Sierra Q's https://auszookers.com/forum/viewtopic.php?f=5&t=21305 |
Page 1 of 1 |
| Author: | barney7779 [ Sun Apr 24, 2011 1:38 pm ] |
| Post subject: | Vit Brakes to Sierra Q's |
Hey guys Finished fitting up the 97 LWB vitara rotors and calipers to my Sierra today and have struck a problem The hump/bowl/piston housing??? the round bit on the back of the caliper where the hose and bleeder nipple screw in, As the piston is pushed out when th brake is applied the bottom of the round bit hits on the top of the outer two king pin bolts Hope i explained that bit right. Will get pics if needed Anyway Has anyone else had this problem or have i just done a shit job of putting the calipers on? Any help or advice would be great |
|
| Author: | atari4x4 [ Sun Apr 24, 2011 1:44 pm ] |
| Post subject: | Re: Vit Brakes to Sierra Q's |
97 LWB Vitara, could be a SV620, these are larger again than the SE416 LWB |
|
| Author: | barney7779 [ Sun Apr 24, 2011 1:46 pm ] |
| Post subject: | Re: Vit Brakes to Sierra Q's |
Brakes came off the same car my 1.6L came out of so they are not the 2L brakes Bought the whole car to get the motor and bits i wanted for the conversion. Should also add that the pads only have about 4mm maybe 5mm left on them so the caliper is sliding a long way and it only just touches the top of the bolts. |
|
| Author: | steak_knife [ Sun Apr 24, 2011 7:44 pm ] |
| Post subject: | Re: Vit Brakes to Sierra Q's |
Stick new pad's in em... I wondered about this, looking at the caliper with new pad's & thinking they may interfere on dead pad's.. bendix do a nice 4wd pad for em, highly recommend em... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|