| auszookers.com https://auszookers.com/forum/ |
|
| Do I need a new Tapper cover? https://auszookers.com/forum/viewtopic.php?f=5&t=21368 |
Page 1 of 1 |
| Author: | shane1992 [ Tue Apr 26, 2011 11:33 am ] |
| Post subject: | Do I need a new Tapper cover? |
Hey guys, in the process of rebuilding a G16 to put in my zook. I dropped the Tapper cover and a small piece snapped off, it is the parts that meets up with the timing belt cover.... The crank will be exposed a tiny bit when its back together... 
Should I buy a new one? Or leave it and it will be sweet? Or get some moulding stuff ? Thanks, Shane. |
|
| Author: | stockman [ Tue Apr 26, 2011 11:41 am ] |
| Post subject: | Re: Do I need a new Tapper cover? |
Is it cast alloy? |
|
| Author: | Joe [ Tue Apr 26, 2011 11:48 am ] |
| Post subject: | Re: Do I need a new Tapper cover? |
Why is the cam gear imprinted into it 
|
|
| Author: | shane1992 [ Tue Apr 26, 2011 11:50 am ] |
| Post subject: | Re: Do I need a new Tapper cover? |
Not sure what there made of to be honest :S And I just noticed that too Joe, haha |
|
| Author: | Vits93 [ Tue Apr 26, 2011 12:40 pm ] |
| Post subject: | Re: Do I need a new Tapper cover? |
Yeah mate you'll need a new one or you could use some aluminium putty to glue it back on but you need it for correct cam pulley alinement the part that broke off will have a notch in it. |
|
| Author: | Rockhopper [ Tue Apr 26, 2011 7:51 pm ] |
| Post subject: | Re: Do I need a new Tapper cover? |
get a new rocker cover. If you try and bog it, you'll probably have more issues with the cam gear clearance. As Joe mentioned why is the cam gear imprinted on it?? I think thats going to be a more important issue for you at the moment |
|
| Author: | Fatzook [ Tue Apr 26, 2011 9:30 pm ] |
| Post subject: | Re: Do I need a new Tapper cover? |
I have one here if you need it. $25 plus post. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|