doh. ok, fair enough
| auszookers.com https://auszookers.com/forum/ |
|
| Hard brake line fitting sizes https://auszookers.com/forum/viewtopic.php?f=5&t=21389 |
Page 1 of 1 |
| Author: | weaves [ Wed Apr 27, 2011 6:27 am ] |
| Post subject: | Hard brake line fitting sizes |
Hey guys, I'm doing the NT to WT swap, and i have to run the two seperate brake lines to each brake cylinder on the rear, i've decided to just make new hard lines across the diff. I have the double flaring tool, bender and cutter, i just don't know what size fitting is needed to fit into the flexible hose, and the brake cylinders, can anyone help me out with these sizings? weaves |
|
| Author: | tmb99 [ Wed Apr 27, 2011 7:16 am ] |
| Post subject: | Re: Hard brake line fitting sizes |
I was just reading this last night! Got some made the other day my invoice says 10mm with 1mm seat... I'll have a look when I get home see if it has any other info. |
|
| Author: | BenT [ Wed Apr 27, 2011 8:46 am ] |
| Post subject: | Re: Hard brake line fitting sizes |
Yep, they are M10x1 |
|
| Author: | 31zook [ Wed Apr 27, 2011 9:29 am ] |
| Post subject: | Re: Hard brake line fitting sizes |
PS: aint you running the DS flexy line into the DS drum, then across the axle? from the flexy into a T-piece, then going either way? you would need another bleeding nipple if you do it the second way... |
|
| Author: | weaves [ Wed Apr 27, 2011 9:58 am ] |
| Post subject: | Re: Hard brake line fitting sizes |
mine has 2 bleed nipples as it is, it has 2 flex lines running from the chassis to the diff, then two hard lines running to each side, bleed nipples on both sides. Thanks for the sizing guys, saves me having to pull it all apart before ordering parts. weaves |
|
| Author: | 31zook [ Wed Apr 27, 2011 9:59 am ] |
| Post subject: | Re: Hard brake line fitting sizes |
doh. ok, fair enough
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|