| auszookers.com https://auszookers.com/forum/ |
|
| GV Air Con Compressor Bearing/Pulley https://auszookers.com/forum/viewtopic.php?f=5&t=21500 |
Page 1 of 1 |
| Author: | GRANDBAZOOKA [ Sat Apr 30, 2011 11:01 pm ] |
| Post subject: | GV Air Con Compressor Bearing/Pulley |
After multiple water crossings in my 1998 2.5 v6 grand vitara the air con compressor bearing sounds a bit dry and is very noisy. Has anyone had any dealings with changing a bearing/pulley? Is it expensive? Genuine or non genuine parts? Starting to annoy me as its getting louder and louder. 
|
|
| Author: | Taylor74 [ Sat Apr 30, 2011 11:40 pm ] |
| Post subject: | Re: GV Air Con Compressor Bearing/Pulley |
The cheapest way would be to get a pully second hand,,, They use the same compressor as BB Jimny and Type 3 Baleno. The compressors are farly common to fail now days so there should be a pully or 2 floating around somewhere. |
|
| Author: | steak_knife [ Sat Apr 30, 2011 11:58 pm ] |
| Post subject: | Re: GV Air Con Compressor Bearing/Pulley |
10mm allan key, 10mm spanner & cir clip pliers, easy... |
|
| Author: | steak_knife [ Sat Apr 30, 2011 11:59 pm ] |
| Post subject: | Re: GV Air Con Compressor Bearing/Pulley |
steak_knife wrote: 10mm allan key, 10mm spanner & cir clip pliers, easy...
 & a 12mm spanner.
|
|
| Author: | GRANDBAZOOKA [ Sun May 01, 2011 3:54 am ] |
| Post subject: | Re: GV Air Con Compressor Bearing/Pulley |
Thank you for the advice. So is it possible to replace the pulley whilst the A/C compressor is still in the car or will i have to remove it??? |
|
| Author: | steak_knife [ Sun May 01, 2011 5:59 am ] |
| Post subject: | Re: GV Air Con Compressor Bearing/Pulley |
I've done it, but i'm used to working with my hand's & arm's in stupid place's... Pull your radiator out & you'll piss it in.. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|