| auszookers.com https://auszookers.com/forum/ |
|
| Got a prob with sierra https://auszookers.com/forum/viewtopic.php?f=5&t=21769 |
Page 1 of 1 |
| Author: | 607CHA [ Sun May 08, 2011 8:47 am ] |
| Post subject: | Got a prob with sierra |
When driving my Sierra today it developed a prob that comes and goes. Sometimes when when I pit the clutch in the whole car vibrates and continues after the clutch is out and vibrates when I accelerate. This prob comes and goes. Please all help welcome. Cause if not sorted I'm going to a pootrol. |
|
| Author: | S13RR4 [ Sun May 08, 2011 8:50 am ] |
| Post subject: | Re: Got a prob with sierra |
sounds like uni joints to me, I had same problem Jump under the car and see how much play is in them, should be no more than half a mm |
|
| Author: | 607CHA [ Sun May 08, 2011 8:53 am ] |
| Post subject: | Re: Got a prob with sierra |
Shouldn't the vibration be there all the time? |
|
| Author: | steak_knife [ Sun May 08, 2011 8:55 am ] |
| Post subject: | Re: Got a prob with sierra |
Seized uni, eng mount/mount's, transfer mount's, loose g/box bolt's ect ect ect |
|
| Author: | whincup [ Sun May 08, 2011 8:58 am ] |
| Post subject: | Re: Got a prob with sierra |
S13RR4 wrote: sounds like uni joints to me, I had same problem
Jump under the car and see how much play is in them, should be no more than half a mm X2. same issue i had before i replaced my uni... |
|
| Author: | S13RR4 [ Sun May 08, 2011 9:01 am ] |
| Post subject: | Re: Got a prob with sierra |
607CHA wrote: Shouldn't the vibration be there all the time?
no because sometimes the uni/drive shaft runs in line so to speak but once you change the load on it because there is play in the uni it becomes out of balance. That's how I reasoned it anyway |
|
| Author: | 607CHA [ Sun May 08, 2011 9:16 am ] |
| Post subject: | Re: Got a prob with sierra |
thanks for all the help. ill jump under and look tomorrow and let you know. |
|
| Author: | 607CHA [ Sun May 08, 2011 9:31 am ] |
| Post subject: | Re: Got a prob with sierra |
Just another quick question. Should the front drive shaft turn while on 2wd when moving is this the wind turning it. |
|
| Author: | steak_knife [ Sun May 08, 2011 9:53 am ] |
| Post subject: | Re: Got a prob with sierra |
607CHA wrote: Just another quick question. Should the front drive shaft turn while on 2wd when moving is this the wind turning it.
No & no.... |
|
| Author: | coily96 [ Sun May 08, 2011 10:34 am ] |
| Post subject: | Re: Got a prob with sierra |
front hubs still locked in? |
|
| Author: | 607CHA [ Sun May 08, 2011 11:24 am ] |
| Post subject: | Re: Got a prob with sierra |
No but right one is pretty dodge |
|
| Author: | SSSIERA [ Sun May 08, 2011 2:14 pm ] |
| Post subject: | Re: Got a prob with sierra |
jump under and see if u can spin the front dive shaft by hand. |
|
| Author: | Scrawny [ Sun May 08, 2011 7:08 pm ] |
| Post subject: | Re: Got a prob with sierra |
In 2wd, with the hubs set to free, the front shaft should spin freely. If it doesn't then one or both of the hubs are holding on. |
|
| Author: | 607CHA [ Sun May 08, 2011 7:13 pm ] |
| Post subject: | Re: Got a prob with sierra |
It spins freely. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|