| auszookers.com https://auszookers.com/forum/ |
|
| G16b wire Verification Help https://auszookers.com/forum/viewtopic.php?f=5&t=22017 |
Page 1 of 1 |
| Author: | MG410 [ Tue May 17, 2011 2:28 am ] |
| Post subject: | G16b wire Verification Help |
I have a G16b in the Maruti which was removered [I didn't remove) from a already running converted Maruti.I need to Verify a few wires which were not marked 1.Yellow black trace (A9) 2.White (A1)-I beleive Tail Light + 3.Couple Black-wires I beleive are Earth Also which connection is to activate starter solenoid as I have traced to A2 socket on ECM,all do I just join (solder) with old wire circuit |
|
| Author: | MG410 [ Tue May 17, 2011 2:30 am ] |
| Post subject: | Re: G16b wire Verification Help |
Black wires are Black just look Blue in Photo strange |
|
| Author: | royce [ Tue May 17, 2011 2:38 am ] |
| Post subject: | Re: G16b wire Verification Help |
Black with blue trace is Sensor Earth Yellow and black is VSS? I think, not sure White might be ECU battery power starter should be black with yellow trace, which hooks to black with yellow trace in teh sierra loom 
This is all based on g13bb being the same colours and my memory being correct |
|
| Author: | MG410 [ Tue May 17, 2011 5:29 am ] |
| Post subject: | Re: G16b wire Verification Help |
Starter is same as I track it to ecm,is their a input connection on ecm or do I connect original start wire between starter & ecm |
|
| Author: | royce [ Tue May 17, 2011 5:34 am ] |
| Post subject: | Re: G16b wire Verification Help |
yeah starter is jsut an input, connect it off the original start wire |
|
| Author: | 94BAZOOKA [ Tue May 17, 2011 6:44 am ] |
| Post subject: | Re: G16b wire Verification Help |
MG410 wrote: Starter is same as I track it to ecm,is their a input connection on ecm or do I connect original start wire between starter
& ecm You have a pm |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|