| auszookers.com https://auszookers.com/forum/ |
|
| Are they serious? https://auszookers.com/forum/viewtopic.php?f=5&t=22118 |
Page 1 of 1 |
| Author: | Richo [ Fri May 20, 2011 7:14 am ] |
| Post subject: | Are they serious? |
just rang Suzistore to see if they had a 2nd hand Baleno motor, now i know these guys can be a bit over the top for prices as i've been going there for years but to be told $3000 for a motor out of a wreck as is.. Seems a tad pricey to me but as i've never looked into buying a 2nd hand 1.6 i'm not too sure, how does this sound to the people of AZ?? Richo |
|
| Author: | atari4x4 [ Fri May 20, 2011 7:17 am ] |
| Post subject: | Re: Are they serious? |
Get Alien to call for you... anyone would think they sponsor him. Alien
|
|
| Author: | buzbox [ Fri May 20, 2011 7:20 am ] |
| Post subject: | Re: Are they serious? |
You can buy a registered baleno for $3000 Of course it depends on the motor, but $800-1500 is about average for a 2nd hander from teh wreckers. For $3000 I'd expect it to be reco'd. |
|
| Author: | Joe [ Fri May 20, 2011 7:27 am ] |
| Post subject: | Re: Are they serious? |
It might be the motor i was gunna get off them, if it is it's got fark all kays on it |
|
| Author: | Marked [ Fri May 20, 2011 7:28 am ] |
| Post subject: | Re: Are they serious? |
I had one installed in my Vit which had done low ks, I saw the car it came out of. That was 3 grand, 40thou motor, and installed. 3 month warranty. |
|
| Author: | Richo [ Fri May 20, 2011 7:31 am ] |
| Post subject: | Re: Are they serious? |
Another wrecker just quoted me 1600 for a late model (coil pack) 1600 with Harness so definately a bit cheaper, i guess i might ask for Brian next time i call suzistore as the girl there usually quotes me high prices with a bit of attitude free of charge |
|
| Author: | stockman [ Fri May 20, 2011 7:39 am ] |
| Post subject: | Re: Are they serious? |
You have to remember they are there to make money. If you are going to do all the work yourself, but a runner. That way you can take it for a drive before hand. Sell parts you won't need, and sell the rest to the scrapy when you have finished. It's a bit more time consuming, but at the end of the conversion you can recoup alot of the initial out lay back. When you are in the process of selling off the parts you don't need for as much as you can get for them, have a think back to why you started this thread |
|
| Author: | Richo [ Fri May 20, 2011 7:46 am ] |
| Post subject: | Re: Are they serious? |
stockman wrote: When you are in the process of selling off the parts you don't need for as much as you can get for them, have a think back to why you started this thread
Um to found out if $3000 is a reasonable price for a 2nd hand motor out of a wreck |
|
| Author: | stockman [ Fri May 20, 2011 7:52 am ] |
| Post subject: | Re: Are they serious? |
Richo wrote: stockman wrote: When you are in the process of selling off the parts you don't need for as much as you can get for them, have a think back to why you started this thread Um to found out if $3000 is a reasonable price for a 2nd hand motor out of a wreck |
|
| Author: | Bazooka [ Fri May 20, 2011 8:25 am ] |
| Post subject: | Re: Are they serious? |
Richo wrote: stockman wrote: When you are in the process of selling off the parts you don't need for as much as you can get for them, have a think back to why you started this thread Um to found out if $3000 is a reasonable price for a 2nd hand motor out of a wreck The word Whooosh comes to mind LOL |
|
| Author: | Richo [ Fri May 20, 2011 8:34 am ] |
| Post subject: | Re: Are they serious? |
`No whooosh here just didn't see it as relevant as all i want to buy is a 2nd hand motor and not turn my driveway into a wreckers yard |
|
| Author: | Nagz [ Fri May 20, 2011 9:08 am ] |
| Post subject: | Re: Are they serious? |
you can buy a whole car for that much, that is ridiculous. I think we should boycott |
|
| Author: | vermin [ Fri May 20, 2011 9:31 am ] |
| Post subject: | Re: Are they serious? |
I paid about that for my Liana M18a VVT from them. That engine had about 35,000kms. |
|
| Author: | alien [ Fri May 20, 2011 9:45 am ] |
| Post subject: | Re: Are they serious? |
atari4x4 wrote: Get Alien to call for you... anyone would think they sponsor him.
Alien haha maybe if it was for me i might get a better price, but wouldnt be way cheaper =) if you've got a problem with it why not ask the question "WHY" over the phone rather than borking at it and then complaining on a forum where you'll get no real answer?
|
|
| Author: | Fatzook [ Fri May 20, 2011 10:37 am ] |
| Post subject: | Re: Are they serious? |
Thats absurd! They go for $800-$1500 everywhere else. Rhino and Want33's both picked up running balenos for $250 or less each. Tell them to sit on their $3K motor and rotate. |
|
| Author: | boostedbrick [ Fri May 20, 2011 10:46 am ] |
| Post subject: | Re: Are they serious? |
I picked up a SPOA sierra with a 1.6 for $1700.. Sold the bits i didnt want and cost me $800 in the end... Theres some bloody cheap balenos going through the auctions.. |
|
| Author: | bakerboy [ Fri May 20, 2011 3:17 pm ] |
| Post subject: | Re: Are they serious? |
I've scored a baleno for $200 and another for $600, $3000 is a rip off Btw both were complete cars, the coil pack models as well |
|
| Author: | shandy92 [ Fri May 20, 2011 3:50 pm ] |
| Post subject: | Re: Are they serious? |
i asked Brian on wed how much it would cost for a REBUILD 1.6 efi, and he said $2500, and 1.3 is $2200. try and think how much it would cost for: -skimmed head and or maybe block (add more if repair needs doing, (cracked or un-servicable) -pistons, -rings -crankshaft/camshaft bearings, -crank balance, weld/regrind -cam balance, weld/regrind -genuin, oil seals-gear cover -new water pump -timing belt, -various gaskets -fix or repair wiring harness - plus all the labor to do it all suzistore is the cheapest full engine rebuilder in perth by $300 for a 1.6 and $400 for a 1.3L. instead of assuming stuff, just ask. remember its under a warranty, some stores dont offer this, plus other stores make you fit ur own timing belt and water pump |
|
| Author: | steak_knife [ Sat May 21, 2011 3:46 am ] |
| Post subject: | Re: Are they serious? |
shandy92 wrote: some stores dont offer this, plus other stores make you fit ur own timing belt and water pump
|
|
| Author: | MacDaddy [ Sat May 21, 2011 6:39 am ] |
| Post subject: | Re: Are they serious? |
Without actually knowing what you asked, and how you said it, its difficult to say if it is too much... you really should go back to Suzistore and talk to them, and clarify, ask, why they are asking $3000, as i know, if they are charging $3000 for a low km engine, they would have a good reason why... When Suzistore discovered a crack in my old Vits engine block, they quoted me, for a 2nd hand Baleno engine, $3500, but that included engine fitting/setup as well... |
|
| Author: | Che [ Sat May 21, 2011 7:26 am ] |
| Post subject: | Re: Are they serious? |
So Suzistore actually rebuild the engine or is it done elsewhere? |
|
| Author: | Joe [ Sat May 21, 2011 7:30 am ] |
| Post subject: | Re: Are they serious? |
che_guitarra wrote: So Suzistore actually rebuild the engine or is it done elsewhere?
They build the engines there but they get there machining done else where |
|
| Author: | Richo [ Sat May 21, 2011 7:54 am ] |
| Post subject: | Re: Are they serious? |
The $3000 was for engine supply only, no fitting and she didn't offer a warranty, saying that it was difficult getting any info out of her and she really made it sound like they did not really want to part with the engine, she made a point of saying that it was their only one and how rare they are. |
|
| Author: | smiffkid [ Sat May 21, 2011 7:58 am ] |
| Post subject: | Re: Are they serious? |
brian is deffinitly the guy to talk to, when we bought our motor it cost us 200, from wreckers they where like 1600, that was last yr, prices shouldn have risen that much |
|
| Author: | Che [ Sat May 21, 2011 8:07 am ] |
| Post subject: | Re: Are they serious? |
Richo, I copped that off her too - and she talked me out of a 1.6 carby conversion saying how common it was for g16a blocks to crack??? She made it sound like rebuilding a 1.3 was a massive chore too... talk about scaring away customers |
|
| Author: | Teracis [ Sat May 21, 2011 8:10 am ] |
| Post subject: | Re: Are they serious? |
che_guitarra wrote: Richo, I copped that off her too - and she talked me out of a 1.6 carby conversion saying how common it was for g16a blocks to crack???
She made it sound like rebuilding a 1.3 was a massive chore too... talk about scaring away customers Spoke to one stop about the cracking of 1.6's and was told that it's because they overheat due to lack of maintenance. I'd still like to go g16b, just got to look after the thing that's all, not really hard is it? |
|
| Author: | alien [ Sat May 21, 2011 9:05 am ] |
| Post subject: | Re: Are they serious? |
the g16b has more webbing on the block so its stronger. |
|
| Author: | royce [ Sat May 21, 2011 9:12 am ] |
| Post subject: | Re: Are they serious? |
hmmm time waster on a phone call and you cop the full price to make a time waster go away sounds fair to me |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|