auszookers.com
https://auszookers.com/forum/

engine problems
https://auszookers.com/forum/viewtopic.php?f=5&t=2213
Page 1 of 1

Author:  Mike [ Mon Jun 02, 2008 12:23 am ]
Post subject:  engine problems

I've been fixing a few bits and pieces since i got my zook and well i finally got to the motor so i got a mate to give me a hand. we set the timing and tuned it up and got it running real nice then we adjusted the valves and thats where my problem started i bolted the valve cover back on and went to start it and it just wouldn't start so i checked the valves again and tried it again and still didn't start. it wasn't turning over the best so i thought it might of been the battery so i replaced that and that didn't really help now i think the starter motor has had it because it grinds and only works half time. has anyone had similar problems? i'm new to this sort of stuff so any help or advice would be muchly apreciated

Cheers
Mike

Author:  royce [ Mon Jun 02, 2008 12:33 am ]
Post subject:  Re: engine problems

did you move or remove the distributor when you pulled the valve cover off?

Author:  Mike [ Mon Jun 02, 2008 12:50 am ]
Post subject:  Re: engine problems

nah when it was running we set it at 8degrees BTDC like it says on the bonnet and didn't touch it after that

Author:  royce [ Mon Jun 02, 2008 12:54 am ]
Post subject:  Re: engine problems

did you pull the leads off or the cap off to get the valve cover on and off?

sure nobody moved the dizzy? very hard to get the cover off without it

Author:  Mike [ Mon Jun 02, 2008 1:02 am ]
Post subject:  Re: engine problems

i'm pretty sure, i checked the firing order before i reconected the leads i checked to see if it was was getting spark with an old plug and it wasn't getting the brightest spark

Author:  Rockhopper [ Tue Jun 24, 2008 3:06 am ]
Post subject:  Re: engine problems

sounds like one or more of the valves aren't opening which could cause a compression lockup and hence, the slow cranking.I would check the valve clearances again. Other than that it sounds a bit like retarded timing.

Author:  Mike [ Tue Jun 24, 2008 3:12 am ]
Post subject:  Re: engine problems

Rockhopper wrote:
sounds like one or more of the valves aren't opening which could cause a compression lockup and hence, the slow cranking.I would check the valve clearances again. Other than that it sounds a bit like retarded timing.


someone told me that if a car blows black smoke it can be the rings or the vavles i'm not sure if thats true or not but it used to blow shit loads of smoke could that have something to do with it?

Author:  11_evl [ Tue Jun 24, 2008 10:12 am ]
Post subject:  Re: engine problems

Mike wrote:
Rockhopper wrote:
sounds like one or more of the valves aren't opening which could cause a compression lockup and hence, the slow cranking.I would check the valve clearances again. Other than that it sounds a bit like retarded timing.


someone told me that if a car blows black smoke it can be the rings or the vavles i'm not sure if thats true or not but it used to blow shit loads of smoke could that have something to do with it?
smoke

black = fuel/ running rich

blue = oil burning, rings, valve stem seals

white = trans oil, brake fluid burning

Author:  steve [ Tue Jun 24, 2008 10:34 am ]
Post subject:  Re: engine problems

11_evl wrote:
black = fuel/ running rich

blue = oil burning, rings, valve stem seals

white = trans oil, brake fluid burning


excessive amounts of steam = water being pumped straight in to manifold :oops:

Author:  Mike [ Tue Jun 24, 2008 9:57 pm ]
Post subject:  Re: engine problems

it blew blacks smoke then i added some no smoke now its sort of light grey

Author:  Rockhopper [ Wed Jun 25, 2008 1:28 am ]
Post subject:  Re: engine problems

Black smoke means it's getting too much fuel

Author:  Mike [ Wed Jun 25, 2008 1:32 am ]
Post subject:  Re: engine problems

its never really run that lean with the weber on it. everyone has told me that its the rings and its only going to last about 5 mins

Author:  11_evl [ Wed Jun 25, 2008 1:36 am ]
Post subject:  Re: engine problems

Mike wrote:
it blew blacks smoke then i added some no smoke now its sort of light grey

that stuff is no good in the fuel tank

Author:  Mike [ Wed Jun 25, 2008 1:39 am ]
Post subject:  Re: engine problems

11_evl wrote:
Mike wrote:
it blew blacks smoke then i added some no smoke now its sort of light grey

that stuff is no good in the fuel tank


its not in there :lol: i put it in after i changed the oil

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/