just finished getting the wiper motor out.... wasn't too bad. it is in the top corner of the on the passenger side. you basically take the top three strews out, the two on the side and a few on the bottom and you can pull the dash forward and twist it down on the passenger side enough to get a screw driver to the motor. the four screws were very tight though.
I ended up taking the steering wheel off so i could get a better look at the linkages.
It looks like the motor burnt out from corrosion on the shaft of where the wiper blades attach to the car. it was very tight to move it even with your hand. I think salt water may have gotten past the plastic covers and into the shaft over time.
I am surprised this isn't more of a common fault.
