| auszookers.com https://auszookers.com/forum/ |
|
| Jimny PS pump bracket fitment https://auszookers.com/forum/viewtopic.php?f=5&t=22283 |
Page 1 of 1 |
| Author: | Daz7 [ Wed May 25, 2011 11:11 pm ] |
| Post subject: | Jimny PS pump bracket fitment |
Have purchased a complete Jimny power steering setup to transplant into the Sierra. After reading the posts about how it all just bolts up have came across a problem. There's 3 mounting points on the pump bracket (I'm informed its from a 13bb) and only the top two of these line up on the Sierra block - see photos. Whats the solution people? I don't have the belt adjuster either, presume this will bolt on correct? 
|
|
| Author: | steak_knife [ Thu May 26, 2011 7:08 am ] |
| Post subject: | Re: Jimny PS pump bracket fitment |
Daz7 wrote: There's 3 mounting points on the pump bracket (I'm informed its from a 13bb) and only the top two of these line up on the Sierra block - see photos. Whats the solution people? Should be 4, I have both BB & B eng's here so I went for a lil walk to looky.. The bottom bolt for the BB doesn't exist on the older B block. There also should be a smaller hole that bolt to the front of the block, if you have those 3 ( top 2 & front one ) IMO that will be enough... Or just mark a third hole where you have a thread in the block & drill a third hole in the bracket.. |
|
| Author: | Daz7 [ Thu May 26, 2011 11:17 pm ] |
| Post subject: | Re: Jimny PS pump bracket fitment |
Thanks for that - appears I've got the older block so will have to see if I can drill a hole in the bracket for the 3rd mounting bolt. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|