if I am wrong and it breaks its not my fault
| auszookers.com https://auszookers.com/forum/ |
|
| Replacing Brake Light Bulb https://auszookers.com/forum/viewtopic.php?f=5&t=22957 |
Page 1 of 1 |
| Author: | rwicks10 [ Fri Jun 17, 2011 10:27 am ] |
| Post subject: | Replacing Brake Light Bulb |
Hey there, I was just wondering if anyone could offer me any advice that will assist me to remove the cover from the tail light assembly. I have undone the two screws at the bottom of the cover, however I am unable to access the globes. The vehicle is a 1997 Vitara. Any advice would be greatly appreciated. Cheers, Rwicks10. |
|
| Author: | royce [ Fri Jun 17, 2011 10:30 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
pull! its held by a clip thing at teh top, pull from teh bottom the whole thing will come out and you can pull the bulb socket out |
|
| Author: | rwicks10 [ Fri Jun 17, 2011 10:32 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
Cheers for that! I just wanted to avoid breaking anything! Many thanks, rwicks10. |
|
| Author: | royce [ Fri Jun 17, 2011 10:33 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
if I am wrong and it breaks its not my fault
|
|
| Author: | lump_a_charcoal [ Sat Jun 18, 2011 1:34 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
royce wrote: if I am wrong and it breaks its not my fault
BWAAhaAH HAha AHA |
|
| Author: | SuziBlu [ Sat Jun 18, 2011 1:46 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
Royce for PM. 
|
|
| Author: | buzbox [ Sat Jun 18, 2011 2:19 am ] |
| Post subject: | Re: Replacing Brake Light Bulb |
Well the 'correct' way, is to pull while slightly pushing up. It will push the clip in so the botton comes out. A flat screw driver can be used to lever it out. To put it back in, put the botton in first then push the top, you will hear the clip, well clip in. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|