Rear bumper relocation is quite simple im sure if your capable of installing a body lift yourself, you should be able to sought out the rear Bar support. as for the front...
invest in a bullbar and modify that to the right height
| auszookers.com https://auszookers.com/forum/ |
|
| Where to get a decent 2" Bodylift kit for Vitara LWB??? https://auszookers.com/forum/viewtopic.php?f=5&t=23109 |
Page 1 of 1 |
| Author: | fluffoffal [ Tue Jun 21, 2011 12:13 pm ] |
| Post subject: | Where to get a decent 2" Bodylift kit for Vitara LWB??? |
Hi. Was wondering if anyone can tell me where to buy a good quality 2" bodylift kit for a LWB vitara from? Preferably one that comes with brackets for front and rear bumper relocation. Oh yeah, I have an ARB bullbar. Would that be more complicated to re-mount than a stock bumper? Also, do you need to modify the gear shifters with a 2" body lift? Thanks in advance. Steve. |
|
| Author: | monley [ Tue Jun 21, 2011 12:14 pm ] |
| Post subject: | Re: Where to get a decent 2" Bodylift kit for Vitara LWB??? |
Here |
|
| Author: | stocker [ Wed Jun 22, 2011 7:01 am ] |
| Post subject: | Re: Where to get a decent 2" Bodylift kit for Vitara LWB??? |
Rear bumper relocation is quite simple im sure if your capable of installing a body lift yourself, you should be able to sought out the rear Bar support. as for the front... invest in a bullbar and modify that to the right height
|
|
| Author: | fluffoffal [ Wed Jun 22, 2011 9:08 am ] |
| Post subject: | Re: Where to get a decent 2" Bodylift kit for Vitara LWB??? |
stocker wrote: Rear bumper relocation is quite simple im sure if your capable of installing a body lift yourself, you should be able to sought out the rear Bar support. as for the front...
invest in a bullbar and modify that to the right height Cool. I already have an arb steel bullbar. Shouldn,t be too hard to modify with a grinder and a weld or two. |
|
| Author: | stocker [ Wed Jun 22, 2011 9:20 am ] |
| Post subject: | Re: Where to get a decent 2" Bodylift kit for Vitara LWB??? |
damn straight... id go with Two on the welds being that there is 2 brackets you need to modify 
I used a bit of 25mm RHS, welded 2 pieces together, then welded that to the bar support. then a bit of threaded rod up the guts to hold the bar support on |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|