There was a guy in the US did one out of RHS - looked quite simple - let me see if I can find the pictures.
Here you go - it may not count as high clearance, but it certainly is no lower than the frame rails - and it has a certain elegance to it.
| auszookers.com https://auszookers.com/forum/ |
|
| GV gearbox cross member https://auszookers.com/forum/viewtopic.php?f=5&t=23175 |
Page 1 of 1 |
| Author: | Built4thrashing [ Thu Jun 23, 2011 6:56 am ] |
| Post subject: | GV gearbox cross member |
Has anyone bought or made a high clearance crossmember for the gearbox on a GV. I bent mine on the last trip out and want to replace it with something stronger that doesnt hang down as much. I thought about using some 10mm thick x 150mm wide steel plate and getting it bent to shape. Is that overkill or can i get away with something slightly thinner? Cheers |
|
| Author: | Fatzook [ Thu Jun 23, 2011 7:04 am ] |
| Post subject: | Re: GV gearbox cross member |
10x100 would be fine. |
|
| Author: | fordem [ Thu Jun 23, 2011 1:38 pm ] |
| Post subject: | Re: GV gearbox cross member |
There was a guy in the US did one out of RHS - looked quite simple - let me see if I can find the pictures. Here you go - it may not count as high clearance, but it certainly is no lower than the frame rails - and it has a certain elegance to it.
|
|
| Author: | atari4x4 [ Thu Jun 23, 2011 1:58 pm ] |
| Post subject: | Re: GV gearbox cross member |
that's nice & looks stronger than the one I got from ODA/JIZZ 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|