The kingcrome freeze ya nuts off stuff ($15) then a brazing torch, to heat it up again. Otherwise buy a leafy
| auszookers.com https://auszookers.com/forum/ |
|
| top radius arm bolt... https://auszookers.com/forum/viewtopic.php?f=5&t=23931 |
Page 1 of 1 |
| Author: | jonno_racing [ Sun Jul 17, 2011 4:07 am ] |
| Post subject: | top radius arm bolt... |
hey guys i am trying to pull my front radius arm out and the bolt in the top of the arm is seezed in the bush.. i had this issue in my rear arms once, but the fix was to cut down the side of the bush.. that isnt going to work in this situation as i need the bush. i have tried heating the bolt up till the bush smoked... and smashing the other end of the bolt with a hammer.. all that got me was a bent mount and fucked bolt.. any ideas? i have also tried crc etc... Phil |
|
| Author: | boostedbrick [ Sun Jul 17, 2011 4:10 am ] |
| Post subject: | Re: top radius arm bolt... |
Last time i had a bolt with this issue, i just kept turning it in the bush until it broke loose.. Took a decent size breaker bar to tear the bush though. |
|
| Author: | jonno_racing [ Sun Jul 17, 2011 4:36 am ] |
| Post subject: | Re: top radius arm bolt... |
boostedbrick wrote: Last time i had a bolt with this issue, i just kept turning it in the bush until it broke loose.. Took a decent size breaker bar to tear the bush though.
yeah i can turn it a good 100' but i dont want to tare the bush as i want it. |
|
| Author: | Lockie666 [ Sun Jul 17, 2011 5:05 am ] |
| Post subject: | Re: top radius arm bolt... |
You need a bigger hammer, got any of that roost off shit? The ice stuff, heat it up then cool it down really fast. I've done it a few times. |
|
| Author: | jonno_racing [ Sun Jul 17, 2011 5:11 am ] |
| Post subject: | Re: top radius arm bolt... |
Lockie666 wrote: You need a bigger hammer, got any of that roost off shit? The ice stuff, heat it up then cool it down really fast. I've done it a few times.
cant hit it any harder. have already bent the mount! nah. not worth it for the little job. the bolt is basicly rusted into the sleeve |
|
| Author: | 31zook [ Sun Jul 17, 2011 6:03 am ] |
| Post subject: | Re: top radius arm bolt... |
The kingcrome freeze ya nuts off stuff ($15) then a brazing torch, to heat it up again. Otherwise buy a leafy
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|