| auszookers.com https://auszookers.com/forum/ |
|
| carby to efi? https://auszookers.com/forum/viewtopic.php?f=5&t=2396 |
Page 1 of 1 |
| Author: | timmmy1 [ Wed Jul 02, 2008 2:36 am ] |
| Post subject: | carby to efi? |
ok this is going to be one of many stupid questions but is it posible to change my carby to a efi system in my 1.3 sierra 92, i am over carbys i ahve had it rebuilt i am running 2 fuel filters a costom joby air filter in my snorkel tube than a stock air filter and still managing to get shit in my carby it runs good as for a couple of months and than after a week end in the bush it will run like a old 2stoke lawn mower missing farting and carying on an stall out every time i pull up at a stop sign or a set of light's and it is driving me up the wall becuase i drive out in the bush (dust, dirt, sand or mud) every week end but it is only doing it like once a month and it normaly ends up with me taking my carby off and doing a rebuild/pulling apart clean and it take a good week end to do proper and i am just a we bit over it so if some one can give me any advice throw it my way. and bake to the main question is there a kit or evern is it posible to change my carby to a efi system? |
|
| Author: | 11_evl [ Wed Jul 02, 2008 10:05 am ] |
| Post subject: | Re: carby to efi? |
i have a manifold modifyed to fit a ea falcon center point injection throttle body, there is a few different options if your willing to do a bit of custom work or just try find a 8v center point set up with ecu and manifold and wiring.. thats probably the easiest. look around if you can find an aftermarket ecu for cheap than you can use almost any throttle body you can mount on |
|
| Author: | royce [ Wed Jul 02, 2008 1:29 pm ] |
| Post subject: | Re: carby to efi? |
11_evl is pretty spot on there back to your problem, have you had your tank cleaned and replaced the hoses? you could be getting rust particles shaking loose or the inside of the hoses could be perishing, both of which will give you massive headaches with EFI |
|
| Author: | timmmy1 [ Wed Jul 02, 2008 8:41 pm ] |
| Post subject: | Re: carby to efi? |
thank you for the feed back do i just look around at a wrekers or wat and would a efi set up off gti swift bolt on or be very close? |
|
| Author: | BlueSuzy [ Wed Jul 02, 2008 8:49 pm ] |
| Post subject: | Re: carby to efi? |
you will have to try the normal swift tbi, They are abit rare i think. Considering haw many carbies swifts there are... The gti's have a different head, and manifold |
|
| Author: | joeblow [ Wed Jul 02, 2008 8:58 pm ] |
| Post subject: | Re: carby to efi? |
just dont use a 1.6 swift throttle body as these are too big for an 8 valve. |
|
| Author: | Damo [ Wed Jul 02, 2008 10:54 pm ] |
| Post subject: | Re: carby to efi? |
joeblow wrote: just dont use a 1.6 swift throttle body as these are too big for an 8 valve.
Huh? How do you figure that? |
|
| Author: | joeblow [ Wed Jul 02, 2008 11:56 pm ] |
| Post subject: | Re: carby to efi? |
as in 16 valve 1.6. |
|
| Author: | MART [ Thu Jul 03, 2008 1:41 am ] |
| Post subject: | Re: carby to efi? |
Have you tried a EFI fuel filter , they are a finer micron and will filter out more crap if your tank is dirty , Cheers Paul. |
|
| Author: | timmmy1 [ Thu Jul 03, 2008 10:21 pm ] |
| Post subject: | Re: carby to efi? |
did suzi ever bring out a sierra with an efi system on them because i heard there was a few geting around down in sydney that were for sale |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|