auszookers.com :: View topic - LJ chromo front end?

yep. buy chromo cvs without the axles from low range.

think i paid about $100 per cv. yes it means either disk swap, or finding 1 litre drum brakes

custom inner axles. we got them made by a friend.

we may have a run being done again soon, but not sure when.

yep. though were looking at full floats rears soon too.

not sure what the cost will be as the cost of steel has gone up since.
ours were some where around the $200 mark per shaft

front shafts? not sure.

i know that the coily rear short side shaft is exact for length with a 50 shaft.

How close in length is a WT right hand/short shaft to a LJ50 shaft?

Author:	sideways [ Tue Jul 19, 2011 4:32 am ]
Post subject:	LJ chromo front end?
So a few of you guys are running a chromo front end in your LJs. Have I got the right idea as to what you do here? From what I figure you use Chromo Sierra CVs and Custom axles? I'm guessing the Sierra CVs means you have to do a disc brake swap? Can I buy the axles off anyone or do I need to get my own made? Of course, I'l need to put rear diff spider gears in the front for the 26 splines, I think that's about it. Am I close or way off? Thanks Hayden

Author:	tonyevans [ Tue Jul 19, 2011 4:42 am ]
Post subject:	Re: LJ chromo front end?
As I understand it you put SJ Joints on LJ housings with LJ diff and axels and SJ drums or disks . Of course this may be wroung

Author:	tanshi [ Tue Jul 19, 2011 4:43 am ]
Post subject:	Re: LJ chromo front end?
yep. buy chromo cvs without the axles from low range. think i paid about $100 per cv. yes it means either disk swap, or finding 1 litre drum brakes custom inner axles. we got them made by a friend. we may have a run being done again soon, but not sure when.

Author:	sideways [ Tue Jul 19, 2011 4:57 am ]
Post subject:	Re: LJ chromo front end?
tanshi wrote: yep. buy chromo cvs without the axles from low range. think i paid about $100 per cv. yes it means either disk swap, or finding 1 litre drum brakes custom inner axles. we got them made by a friend. we may have a run being done again soon, but not sure when. Okay, thanks mate! Let me know when you're doing another run of the axles please! Approximately how much are they? You just run standard Stockman rear ends don't you?

Author:	tanshi [ Tue Jul 19, 2011 5:09 am ]
Post subject:	Re: LJ chromo front end?
yep. though were looking at full floats rears soon too. not sure what the cost will be as the cost of steel has gone up since. ours were some where around the $200 mark per shaft

auszookers.com https://auszookers.com/forum/

LJ chromo front end? https://auszookers.com/forum/viewtopic.php?f=5&t=24008	Page 1 of 1

Author:	sideways [ Tue Jul 19, 2011 5:26 am ]
Post subject:	Re: LJ chromo front end?
tanshi wrote: yep. though were looking at full floats rears soon too. not sure what the cost will be as the cost of steel has gone up since. ours were some where around the $200 mark per shaft Awesome, thanks again mate. Now to just try and keep a spare $500 for when you make them.

Author:	303zuke [ Tue Jul 19, 2011 6:26 am ]
Post subject:	Re: LJ chromo front end?
How close in length is a WT right hand/short shaft to a LJ50 shaft?

Author:	tanshi [ Tue Jul 19, 2011 6:29 am ]
Post subject:	Re: LJ chromo front end?
front shafts? not sure. i know that the coily rear short side shaft is exact for length with a 50 shaft. i picked one up but then never bothered finding a second one for 26 spline upgrade

Author:	303zuke [ Tue Jul 19, 2011 6:48 am ]
Post subject:	Re: LJ chromo front end?
tanshi wrote: front shafts? not sure. i know that the coily rear short side shaft is exact for length with a 50 shaft. I had measured up a WT rear diff to use 2 short shafts to make a shortened diff housing for an LJ50 that would take an air locker and JoeBlow rear discs, and 2 WT short shafts would have made the perfect width.

Author:	tanshi [ Tue Jul 19, 2011 6:51 am ]
Post subject:	Re: LJ chromo front end?
there is about 15-20mm difference in length between coily and WT lj50 shafts are the same as coily down to the mm from memory

Author:	Highway-Star [ Tue Jul 19, 2011 7:04 am ]
Post subject:	Re: LJ chromo front end?
303zuke wrote: How close in length is a WT right hand/short shaft to a LJ50 shaft? Quite a bit different I think. The Sierra short side front are really short. I Did have a 1L one somewhere that I could add 50mm to and get an estimate from.

Author:	3cyl [ Tue Jul 19, 2011 8:47 am ]
Post subject:	Re: LJ chromo front end?
I still have a few axles left from the last batch, heat treated 4140. They are 26 spline inner and 25 spline outer for the crmo CVs. Not sure what it'll cost to send them to you. Mine's twin locked on 32" tyres with 6.5 gears and they're solid. Guess once you get the CVs I can send them. $150 each. (plus post) Guess that should see them to WA under $200 each.

Page 1 of 1	All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/