buzbox did his not to long ago after breaking 2 alloy ones I was there of one of them
| auszookers.com https://auszookers.com/forum/ |
|
| steel housing mod for 92 vit https://auszookers.com/forum/viewtopic.php?f=5&t=24078 |
Page 1 of 1 |
| Author: | tszook [ Thu Jul 21, 2011 1:09 am ] |
| Post subject: | steel housing mod for 92 vit |
vitara steel house for 92 vit whats needed |
|
| Author: | Brett [ Thu Jul 21, 2011 3:07 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
Have a search, there is plenty on here about it. Put a little effort in and people will help you out |
|
| Author: | RIKSTR [ Thu Jul 21, 2011 3:41 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
The housing, everything else will bolt up. |
|
| Author: | jimbo_jones [ Thu Jul 21, 2011 6:13 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
buzbox did his not to long ago after breaking 2 alloy ones I was there of one of them
|
|
| Author: | atari4x4 [ Thu Jul 21, 2011 6:17 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
RIKSTR wrote: The housing, everything else will bolt up.
isn't bolting it up is the easy bit, pretty sure there is more to it than that. |
|
| Author: | skyman [ Thu Jul 21, 2011 8:54 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
tszook wrote: vitara steel house for 92 vit whats needed
Beer, and plenty of it too. 
|
|
| Author: | fire60 [ Thu Jul 21, 2011 8:56 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
I did this mod a couple of years ago. Changed axle and diff housings to steel. fairly easy, you have to pull the axles out, be carefull not to damage the seals in the donor housing when you put the axles back or you will have an oil leak that you will only discover when it is all back together. Some oil on the seals before sliding axles in will help. |
|
| Author: | fire60 [ Thu Jul 21, 2011 8:56 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
I did this mod a couple of years ago. Changed axle and diff housings to steel. fairly easy, you have to pull the axles out, be carefull not to damage the seals in the donor housing when you put the axles back or you will have an oil leak that you will only discover when it is all back together. Some oil on the seals before sliding axles in will help. |
|
| Author: | atari4x4 [ Thu Jul 21, 2011 9:06 am ] |
| Post subject: | Re: steel housing mod for 92 vit |
do you have to worry about changing the diff ratio's? |
|
| Author: | fire60 [ Fri Jul 22, 2011 8:22 pm ] |
| Post subject: | Re: steel housing mod for 92 vit |
Ratios depend on what you are using it for, but make sure that the new diff is the same as the old one or the rear. You may have to swap over the crown wheel and pinion to do this. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|