| auszookers.com https://auszookers.com/forum/ |
|
| Help https://auszookers.com/forum/viewtopic.php?f=5&t=24135 |
Page 1 of 1 |
| Author: | russty_2008 [ Fri Jul 22, 2011 10:00 pm ] |
| Post subject: | Help |
Ok I have a g16 b baleno motor in my Sierra and every now and then it wont rev clean like it just splutters and carries on but I disconnected the air flow meter from the air intake and it seems to run fine |
|
| Author: | Damo [ Fri Jul 22, 2011 10:21 pm ] |
| Post subject: | Re: Help |
russty_2008 wrote: Ok I have a g16 b baleno motor in my Sierra and every now and then it wont rev clean like it just splutters and carries on but I disconnected the air flow meter from the air intake and it seems to run fine
Have a look at your airflow meter, it's possible the little element that sits in the airstream may be broken or bent. |
|
| Author: | BlueSuzy [ Sat Jul 23, 2011 1:12 am ] |
| Post subject: | Re: Help |
Balenos didnt have an airflow. They had an airtemp poked into the hose, disconected did no difference for my motor. |
|
| Author: | suzooky87 [ Sat Jul 23, 2011 1:50 am ] |
| Post subject: | Re: Help |
disconnecting it will only cause your car to over fuel the engine and kill all the sensors on the exhaust. and eventually the air system sensors. just like those cheep "performance chips" on ebay. look get all the sensors checked. Air temp. Cam angle. Crank angle. O2 sensor, after manifold and cat. Throttle position sensor (tps) EGR if you have one. and any other u might have. i do not know exactly but i would look into those type of things as well as the usual (dizzy or coil packs, plugs and leads.) |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|