| auszookers.com https://auszookers.com/forum/ |
|
| vitara driveline problem https://auszookers.com/forum/viewtopic.php?f=5&t=24165 |
Page 1 of 1 |
| Author: | dave07 [ Sat Jul 23, 2011 12:49 pm ] |
| Post subject: | vitara driveline problem |
Today my vitara started making a weird whining noise. last week i had massive vibrations from the rear. I have the calmini 3" lift and i found my a frame in the rear the nut holding the diff in place had come loose i titghtened it up and all was good except i has still getting some loud sounds from the rear but today while driving i got a weird whining noise it would come in intermittently at no particular speed or gear. Has anyone with the calmini lift experienced this noise? |
|
| Author: | tszook [ Sun Jul 24, 2011 7:47 am ] |
| Post subject: | Re: vitara driveline problem |
check tail shaft angle and then look at rear wheels bearings jack car up and put on stands first and put in drive let clutch out slowly and see if the nosie is from the axle area or centre of the diff |
|
| Author: | stocker [ Sun Jul 24, 2011 9:36 am ] |
| Post subject: | Re: vitara driveline problem |
i had a similar thing when i put my lift in, turns out rear wheel bearings were shot |
|
| Author: | atari4x4 [ Sun Jul 24, 2011 1:29 pm ] |
| Post subject: | Re: vitara driveline problem |
how much thread do you have showing on the heim joint? |
|
| Author: | Joe [ Sun Jul 24, 2011 1:32 pm ] |
| Post subject: | Re: vitara driveline problem |
atari4x4 wrote: how much thread do you have showing on the heim joint?
Last time i seen it it was screwed all the way in |
|
| Author: | atari4x4 [ Sun Jul 24, 2011 1:33 pm ] |
| Post subject: | Re: vitara driveline problem |
yeah mine is pretty much the whole way in. |
|
| Author: | Joe [ Sun Jul 24, 2011 1:36 pm ] |
| Post subject: | Re: vitara driveline problem |
Mine is 3/4 of the way out, if i screw it in any more i get a vibration from the tail shaft |
|
| Author: | Lockie666 [ Sun Jul 24, 2011 1:50 pm ] |
| Post subject: | Re: vitara driveline problem |
Uni - Tailshaft, check for play in them Dave. |
|
| Author: | alien [ Sun Jul 24, 2011 1:55 pm ] |
| Post subject: | Re: vitara driveline problem |
whining sounds in my sierra is usually a wheel bearing, but its also accompanied by a vibration and a clunk on cornering... |
|
| Author: | dave07 [ Sun Jul 24, 2011 2:01 pm ] |
| Post subject: | Re: vitara driveline problem |
thanks guys yeah the unis are fine. my heim jont is 3/4 of the way out so my rear coils are pretty much straight. yeah i might check my bearings cause thats all i can think of |
|
| Author: | Polar_Bear [ Sun Jul 24, 2011 2:09 pm ] |
| Post subject: | Re: vitara driveline problem |
just be careful how far that heim is screwed out...mine let go cos it was only in by 1/4 of the way
|
|
| Author: | buzbox [ Mon Jul 25, 2011 7:25 am ] |
| Post subject: | Re: vitara driveline problem |
Sometimes I get a whining sound in my car, but I just tell her to shut up. |
|
| Author: | Chop [ Mon Jul 25, 2011 9:43 am ] |
| Post subject: | Re: vitara driveline problem |
Polar_Bear wrote: just be careful how far that heim is screwed out...mine let go cos it was only in by 1/4 of the way
![]() The hiding it copped at the narra 4wd event didnt help it? |
|
| Author: | Polar_Bear [ Mon Jul 25, 2011 12:40 pm ] |
| Post subject: | Re: vitara driveline problem |
Chop wrote: Polar_Bear wrote: just be careful how far that heim is screwed out...mine let go cos it was only in by 1/4 of the way ![]() The hiding it copped at the narra 4wd event didnt help it? dont think it had anything to do with it
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|