auszookers.com
https://auszookers.com/forum/

Petroworks Engine Mounts
https://auszookers.com/forum/viewtopic.php?f=5&t=24291		 Page 1 of 1
Author:  DMAC [ Wed Jul 27, 2011 7:24 am ]
Post subject:  Petroworks Engine Mounts
Just put the bonnet back on the LWB and it doesn't close because the engine is now to high. :oops:

Anybody know how much the Petroworks engine mounts drop the engine?

I would prefer this as opposed to body lift. Low is the new high.
Author:  Ridge [ Wed Jul 27, 2011 8:01 am ]
Post subject:  Re: Petroworks Engine Mounts
You could try trimming a little of the bonnet bracing to clear the manifold.
I don't know anything about the petroworks kit.
Author:  reeceh [ Wed Jul 27, 2011 9:05 am ]
Post subject:  Re: Petroworks Engine Mounts
ive got the petrowrks mounts but still waiting on modifying the sump. Then i could tell you how much it drops the engine in by.
Author:  want33s [ Wed Jul 27, 2011 9:44 am ]
Post subject:  Re: Petroworks Engine Mounts
Petroworks kit is supposed to mount the engine lower than stock .. Up to 20mm lower I believe... Enough so that G16B fits without bonnet mods or body lift...
I have the Petro kit but also have body lift...
Author:  DMAC [ Wed Jul 27, 2011 8:20 pm ]
Post subject:  Re: Petroworks Engine Mounts
Thanks Jas.
I think I will go down this track first then. Sent a query off to petro works for price and availability.
Author:  want33s [ Wed Jul 27, 2011 9:28 pm ]
Post subject:  Re: Petroworks Engine Mounts
If you fit a Petro kit, be sure to make up an aluminium heat sheild for the passengers side engine mount.
I melted one and had to make a replacement.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/