| auszookers.com https://auszookers.com/forum/ |
|
| engine mounts https://auszookers.com/forum/viewtopic.php?f=5&t=25442 |
Page 1 of 1 |
| Author: | honks [ Sun Sep 04, 2011 11:10 am ] |
| Post subject: | engine mounts |
had a broken l/hand engine mount in my 95 sierra about a month ago so i replaced both sides with vl ones trying to put something stronger in but now i seem to notice a fair bit of vibration ar idle and at around 2600-3000 rpm is this a common thing, only reason im asking is that my motor is starting to enjoy a good drink of oil and i'm not sure if it's just some thing in the motor out of balance.Also does any one know anywhere in the brisbane/ipswich area that does exchange motors g13ba as i need my car pretty much all the time and can't afford the down time to get it rebuilt would prefer a straight swap over |
|
| Author: | Fatzook [ Sun Sep 04, 2011 11:41 am ] |
| Post subject: | Re: engine mounts |
I had no dramas with twin VL mounts on my G16B. One thing to look at may be the alignment of the gearbox and transfer. The VL mounts are taller, thus lifting the front of the motor. This will ever so slightly change the angle of the rear of the gearbox. I've no idea if its enough to upset the uni's ( doubt it) but it may be worth looking into. |
|
| Author: | honks [ Sun Sep 04, 2011 6:28 pm ] |
| Post subject: | Re: engine mounts |
i was thinking the same but the vibrations are still there in neutral and bringing the revs up |
|
| Author: | sogone [ Sun Sep 04, 2011 10:52 pm ] |
| Post subject: | Re: engine mounts |
Silly question, but did ya do ya engine mounts properly/tight enough? |
|
| Author: | ashzook94 [ Sun Sep 04, 2011 11:48 pm ] |
| Post subject: | Re: engine mounts |
it might be because the vl engine mounts are made to carry an rb30 not a g13a and at that rev range is where the motor shakes the most so it's goin through the car.... |
|
| Author: | honks [ Mon Sep 05, 2011 4:37 am ] |
| Post subject: | Re: engine mounts |
Sogone: yeh they are tight ashzook: thats what i was thinking but i was curious if any one else has had any trouble with vibrations when using these mounts as a fair few people on here use them and i have seen them recomended a fair bit |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|