| auszookers.com https://auszookers.com/forum/ |
|
| Weber Tuning https://auszookers.com/forum/viewtopic.php?f=5&t=2581 |
Page 1 of 1 |
| Author: | Mike [ Thu Jul 24, 2008 2:03 am ] |
| Post subject: | Weber Tuning |
i've been playing around with my 32/36 weber and i set the idle mixture and idle speed and now it seems the secondaries are working at idle is there a way that that can be adjusted? are the idle speed and mixture the only settings that can be adjusted on these carbies? |
|
| Author: | royce [ Thu Jul 24, 2008 10:59 am ] |
| Post subject: | Re: Weber Tuning |
you can pull em apart and change just bout everything in em if you want secondaries arent working at idle, the whole barrel wont work till air is going through and air wont go through till the throttle is opened right up |
|
| Author: | SuperRoo [ Thu Jul 24, 2008 6:01 pm ] |
| Post subject: | Re: Weber Tuning |
If you dont already have a Weber manual then its worth getting your hands on one. The best one I have seen for a suzuki is from here: http://www.suzukiinfo.com/ If that manual is not suitable then maybe you need one from here: http://www.weberbbq.com.au/ 
|
|
| Author: | Zook_Fan [ Thu Jul 24, 2008 8:15 pm ] |
| Post subject: | Re: Weber Tuning |
how the hell are you going to tune your carby by having a BBQ? |
|
| Author: | Nik [ Thu Jul 24, 2008 11:00 pm ] |
| Post subject: | Re: Weber Tuning |
What makes you think the secondaries are working at idle? They are mechanical and only open when you press the throttle down far enough. A well tuned weber you wont use the secondaries much at all and youd be suprised how economical it is if you stay out of them. What motor are you running, have you done a plug test to check if you have the air/ fuel mix right? my 1600 was jetted at primary/ secondary idle 55 50 main 140 140 air 175 170 aux 3.5 4.5 e tube f50 f50 This set up gave me a nice light brown colour on the plugs. Which is also very close to the suggested set up for a 1300. I now run a 38 syncro with 70 idles 140 mains and 170 airs. Nik |
|
| Author: | Built4thrashing [ Mon Jul 28, 2008 12:11 am ] |
| Post subject: | Re: Weber Tuning |
hey mike where you located. I have played with webers in the past and should be able to help set it up. Im in melb B4T |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|