auszookers.com https://auszookers.com/forum/
Speedo cable https://auszookers.com/forum/viewtopic.php?f=5&t=26794	Page 1 of 1

---

Author:	mudzookacoatsy [ Sun Oct 16, 2011 1:20 am ]
Post subject:	Speedo cable
Hey all trying to put new speedo cable in . Wats the easiest way having trouble. Plz help

---

Author:	steak_knife [ Sun Oct 16, 2011 3:20 am ]
Post subject:	Re: Speedo cable
Leave the out sheath in & just replace the cable.........

---

Author:	mudzookacoatsy [ Sun Oct 16, 2011 9:44 am ]
Post subject:	Re: Speedo cable
Yeh tryed that but old cable was rusted in down the transfer end so had to can it any way. Thanks for info any ways

---

Author:	steak_knife [ Mon Oct 17, 2011 6:49 am ]
Post subject:	Re: Speedo cable
If you do replace the whole thing, tie some strong'ish wire round it before you pull the cable from behind the heater & use it to pull the new one through... It's best to run em where in the original place's, or you'll get a jumpy speedo or a short life out of the cable...

---

Author:	cairns27 [ Wed Oct 21, 2015 7:43 am ]
Post subject:	Re: Speedo cable
I read yesterday where you don't have to drop the cluster, I got my hand up there, but couldn't pull it off. Does it half turn first, or use more force ? Replacing the inner cable only, do I just assume the outer is good behind the heater ?. bye

---

Author:	Kor3y101 [ Wed Oct 21, 2015 8:01 am ]
Post subject:	Re: Speedo cable
Can't say much about the outer but I know to pull it off the cluster I just gave it a good yank and a slight twist at the same time. Think like pulling an aerial cable off a TV.

---

Author:	fordem [ Wed Oct 21, 2015 9:31 am ]
Post subject:	Re: Speedo cable
My TV aerial cable screws on with an "F" connector.

---

Author:	Kor3y101 [ Wed Oct 21, 2015 8:23 pm ]
Post subject:	Re: Speedo cable
There's always one..

---

Page 1 of 1	All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/