auszookers.com
https://auszookers.com/forum/

hilux vs doetsch
https://auszookers.com/forum/viewtopic.php?f=5&t=27162
Page 1 of 1

Author:  607CHA [ Thu Oct 27, 2011 6:51 am ]
Post subject:  hilux vs doetsch

Need new rear shocks thinking of hilux rears or doetsch off low range. lengths must be 650mm- closed or 760+ open. advise or help please

Author:  BlueSuzy [ Thu Oct 27, 2011 7:00 am ]
Post subject:  Re: hilux vs doetsch

Get the bilsteins. Cheap and good quality.

Author:  607CHA [ Thu Oct 27, 2011 7:11 am ]
Post subject:  Re: hilux vs doetsch

How much are the bilsteins? Does anyone know what shocks alien is running with his A frame rear

Author:  BlueSuzy [ Thu Oct 27, 2011 7:16 am ]
Post subject:  Re: hilux vs doetsch

Have a look on lowrange??

Alien aframe rear??

Author:  SierraDan [ Thu Oct 27, 2011 7:20 am ]
Post subject:  Re: hilux vs doetsch

A frame or leaf, doesnt matter. flex it up and measure the length shock you need.

Author:  607CHA [ Thu Oct 27, 2011 8:20 am ]
Post subject:  Re: hilux vs doetsch

Using rear shock bar measurement are as above

Author:  SierraDan [ Thu Oct 27, 2011 8:40 am ]
Post subject:  Re: hilux vs doetsch

http://www.lowrangeoffroad.com/index.ph ... hocks.html

Use the info they have given you to choose.

Author:  BlueSuzy [ Thu Oct 27, 2011 8:49 am ]
Post subject:  Re: hilux vs doetsch

A frame rear is a 3link/4link coil setup.
Not shocks inverted/angled/more inboard at top mount.

Author:  607CHA [ Thu Oct 27, 2011 9:37 am ]
Post subject:  Re: hilux vs doetsch

Sorry for the confusion. I think the doetsch 3000 series dt3600 will be the route i choose. does anyone on az run these. if so what do you think of them

Author:  Red89 [ Thu Oct 27, 2011 11:58 am ]
Post subject:  Re: hilux vs doetsch

I used to run the 3000's on the front and they were perfectly suited to my RUF setup and took a pounding.

Author:  2stroker [ Thu Oct 27, 2011 8:48 pm ]
Post subject:  Re: hilux vs doetsch

607CHA wrote:
Need new rear shocks thinking of hilux rears or doetsch off low range. lengths must be 650mm- closed or 760+ open. advise or help please


Standard rear are 283mm compressed and 544mm extended.

I always remember these lengths because they numbers just happen to be the same as the small and big chev engine cubic inches.

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/