Cable ties and duct tape. Holds anything together
| auszookers.com https://auszookers.com/forum/ |
|
| Fitting winch https://auszookers.com/forum/viewtopic.php?f=5&t=27279 |
Page 1 of 1 |
| Author: | zooky08 [ Mon Oct 31, 2011 6:59 pm ] |
| Post subject: | Fitting winch |
Hey guys I have a non winch arb bar on my Jimmy, It is the airbag one I am wondering if I can cut out a hole to fit a winch. I know the bar isn't design for a winch but will it withstand a winch, also will the mounts hold up. The winch I have is a 9000lb |
|
| Author: | Joshyboy26 [ Tue Nov 01, 2011 12:50 am ] |
| Post subject: | Re: Fitting winch |
its should be ok to cut a hole for the fairlead in it but i would make a completely seperate cradle for the winch that comes off your chassis so the winch doenst affect your bar in any way. because it is not a winch bar the mounts and bar itself is not designed to withstand the forces of a winch and over time you will bend and distort the bar and especially with airbags you dont really wanna fuck that up |
|
| Author: | abclarke [ Tue Nov 01, 2011 4:32 am ] |
| Post subject: | Re: Fitting winch |
Cable ties and duct tape. Holds anything together
|
|
| Author: | ZookFan [ Tue Nov 01, 2011 9:17 am ] |
| Post subject: | Re: Fitting winch |
abclarke wrote: Cable ties and duct tape. Holds anything together
HEHE 
|
|
| Author: | ZookFan [ Tue Nov 01, 2011 9:19 am ] |
| Post subject: | Re: Fitting winch |
because it's a non winch bar... maybe consider fitting some stronger mounting brackets where it attaches to the chassis? and a strong winch cradle? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|