Damn, i'll have to upgrade to a digital torque wrench
| auszookers.com https://auszookers.com/forum/ |
|
| G16 crank pully bolt - torque setting https://auszookers.com/forum/viewtopic.php?f=5&t=2745 |
Page 1 of 1 |
| Author: | Damo [ Wed Aug 13, 2008 4:20 pm ] |
| Post subject: | G16 crank pully bolt - torque setting |
I'm sure I had all this somewhere but when i actually need it... So what is it? 90lb/ft rings a bell. |
|
| Author: | joeblow [ Wed Aug 13, 2008 5:40 pm ] |
| Post subject: | Re: G16 crank pully bolt - torque setting |
92.5 lb/ft. |
|
| Author: | Damo [ Wed Aug 13, 2008 5:46 pm ] |
| Post subject: | Re: G16 crank pully bolt - torque setting |
Damn, i'll have to upgrade to a digital torque wrench
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|