| auszookers.com https://auszookers.com/forum/ |
|
| handbrake light coming on https://auszookers.com/forum/viewtopic.php?f=5&t=2810 |
Page 1 of 1 |
| Author: | andrewa [ Fri Aug 22, 2008 1:11 am ] |
| Post subject: | handbrake light coming on |
as the title says, what would cause the handbrake light to come on while still depessed cheers andrewa. |
|
| Author: | royce [ Fri Aug 22, 2008 1:14 am ] |
| Post subject: | Re: handbrake light coming on |
low brake fluid, same light arent they? |
|
| Author: | andrewa [ Fri Aug 22, 2008 2:16 am ] |
| Post subject: | Re: handbrake light coming on |
i'll check the fluid level tomorrow & see if that makes a difference. |
|
| Author: | mrpham [ Fri Aug 22, 2008 2:18 am ] |
| Post subject: | Re: handbrake light coming on |
My friend had the same thing happen too, everytime we go around the corner the light would come one. Turned out to be low brake fluid |
|
| Author: | Rockhopper [ Fri Aug 22, 2008 11:05 am ] |
| Post subject: | Re: handbrake light coming on |
royce wrote: low brake fluid, same light arent they?
Either that or the switch on the handbrake lever is playing up |
|
| Author: | zook37 [ Fri Aug 22, 2008 11:24 am ] |
| Post subject: | Re: handbrake light coming on |
I had the same problem a few years back with my GV. Turned outto be a faulty handbrake switch. |
|
| Author: | bill929 [ Fri Aug 22, 2008 10:36 pm ] |
| Post subject: | Re: handbrake light coming on |
check ur brake fluid |
|
| Author: | andrewa [ Sat Aug 23, 2008 1:03 am ] |
| Post subject: | Re: handbrake light coming on |
brake fluid was a bit low, topped it up & seems to be ok. |
|
| Author: | Brett [ Sat Aug 23, 2008 1:07 pm ] |
| Post subject: | Re: handbrake light coming on |
if your brake fluid was that low it might be a idea to check your brake pads, the fluid doesn't go anywhere unless you have a leak and slowly goes down as your pads wear. |
|
| Author: | BlueSuzy [ Sat Aug 23, 2008 5:56 pm ] |
| Post subject: | Re: handbrake light coming on |
My top up is usually once a week, My rear drums leak.. Just gotta get the time to put my new pistons in |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|