jack the back up & check the rear diff ratio... maybe you don't have 512's.
did you check the one that came out?
| auszookers.com https://auszookers.com/forum/ |
|
| Heellpp!?!? https://auszookers.com/forum/viewtopic.php?f=5&t=28210 |
Page 1 of 1 |
| Author: | stocker [ Thu Dec 01, 2011 5:41 am ] |
| Post subject: | Heellpp!?!? |
Hey guys and girls... So my problem is just this... Put the new front diff in yadda yadda yadda... No problems there Then *insert dramatic music here* came the test drive... Placed in 4wd high go for a spin down the block. under Acceleration front end lifts up and the back end Boggs down The only thing I can think of is that the diff ratio is wrong... But... I am sure the wrecker counted the teeth right not only In front of me but imam sure As hell I counted them right... 8 teeth on pinion 41 on the crown... Any ideas??? |
|
| Author: | atari4x4 [ Thu Dec 01, 2011 6:23 am ] |
| Post subject: | Re: More crappy diff help... |
jack the back up & check the rear diff ratio... maybe you don't have 512's.
did you check the one that came out? |
|
| Author: | steak_knife [ Thu Dec 01, 2011 7:06 am ] |
| Post subject: | Re: More crappy diff help... |
& don't select 4wd till you have the same ratio front & back again..... |
|
| Author: | stocker [ Thu Dec 01, 2011 7:23 am ] |
| Post subject: | Re: More crappy diff help... |
Shit bugger bitch bum... Just counted the output of the cv's vs drive shaft... By the look of it now I have roughly a 4.9 ratio... Will call the wrecker 2morro but I'm not holding my breath... Does anyone have another 5.125 center with 26 spline axles??? |
|
| Author: | stocker [ Wed Dec 14, 2011 8:25 am ] |
| Post subject: | Re: More crappy diff help... |
Sorry to Rehatch Old Egg's guys, but i still need a 26 Spline 5.125 Front Diff Center to get my zookie going... |
|
| Author: | atari4x4 [ Wed Dec 14, 2011 8:28 am ] |
| Post subject: | Re: More crappy diff help... |
what about the one from the wreck you bought & just run a 22 spline RHS CV? |
|
| Author: | stocker [ Wed Dec 14, 2011 8:29 am ] |
| Post subject: | Re: More crappy diff help... |
atari4x4 wrote: what about the one from the wreck you bought & just run a 22 spline RHS CV?
isn't the 26Spline Much stronger? I am running 31's now... |
|
| Author: | atari4x4 [ Wed Dec 14, 2011 8:39 am ] |
| Post subject: | Re: More crappy diff help... |
i ran a 22 spline inner for a year or more on 31's before building up the steel diff with the RD88 (26spline) locker, never broke it but i'm not a throttle jockey. 
|
|
| Author: | stocker [ Wed Dec 14, 2011 8:40 am ] |
| Post subject: | Re: More crappy diff help... |
hahaha... well since i whacked the 31's under mine, i haven't been anywhere near as rough on mine.... i will change the 22spine one into mine then 
|
|
| Author: | stocker [ Tue Dec 27, 2011 10:38 pm ] |
| Post subject: | Re: More crappy diff help... |
Ok so the finger got pulled out of my butt And I ripped the front diff out to find that it is the right ratio diff 41 teeth on the crown wheel an 8 teeth on the pinion... So to keep you all up to date on what's been done... I fixed the manual locking hub. Replaced the diff. And now the drive line loads up in 4wd. ...help |
|
| Author: | stocker [ Wed Dec 28, 2011 2:38 am ] |
| Post subject: | Re: Heellpp!?!? |
Bump!!! |
|
| Author: | stocker [ Wed Dec 28, 2011 2:40 am ] |
| Post subject: | Re: Heellpp!?!? |
Just pulled the rear it is also a 5.125 taro with 41 teeth on the crown and 8 on the pinion |
|
| Author: | shep [ Wed Dec 28, 2011 2:48 am ] |
| Post subject: | Re: Heellpp!?!? |
did ya do a timbo and put the front diff in upside down? |
|
| Author: | atari4x4 [ Wed Dec 28, 2011 3:43 am ] |
| Post subject: | Re: Heellpp!?!? |
what ratio was the one you broke? EDIT: just saw that you've pulled the rear diff to find it was also 512:1 are you running the same size tyres front & back? 
|
|
| Author: | Chop [ Wed Dec 28, 2011 3:46 am ] |
| Post subject: | Re: Heellpp!?!? |
atari4x4 wrote: what ratio was the one you broke?
EDIT: just saw that you've pulled the rear diff to find it was also 512:1 are you running the same size tyres front & back? That was my next guess, different tyre size? |
|
| Author: | stocker [ Wed Dec 28, 2011 8:48 pm ] |
| Post subject: | Re: Heellpp!?!? |
Hey guys you physically cant put the front diff upside down due to the mount on the pinion. Definitely got the same size tyres front and back 31x11.5r15 |
|
| Author: | stocker [ Thu Dec 29, 2011 12:56 am ] |
| Post subject: | Re: Heellpp!?!? |
Was just thinking it might be binding up between 4wd hi & low... Has anyone had this problem with the vitara transfer case??? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|