| auszookers.com https://auszookers.com/forum/ |
|
| Panhard rod length https://auszookers.com/forum/viewtopic.php?f=5&t=28426 |
Page 1 of 1 |
| Author: | zammit [ Wed Dec 07, 2011 10:16 pm ] |
| Post subject: | Panhard rod length |
Can someone tell me the length of a front panhard rod of a Jimny eye to eye mine just snapped |
|
| Author: | zooky08 [ Wed Dec 07, 2011 10:42 pm ] |
| Post subject: | Re: Panhard rod length |
If some one doesn't beat me to it, I still have my stock ones so I can get you the length dis arvo after work |
|
| Author: | zammit [ Wed Dec 07, 2011 11:20 pm ] |
| Post subject: | Re: Panhard rod length |
Awsome thanks |
|
| Author: | Fatzook [ Wed Dec 07, 2011 11:34 pm ] |
| Post subject: | Re: Panhard rod length |
zammit wrote: Can someone tell me the length of a front panhard rod of a Jimny eye to eye mine just snapped :-(
Awesome!!!
The coily panhards are equally feable. I've just made rushoes the same size as an 80 series. Much beefier. Are you going to replace it with a stock one? Or have a new one made? |
|
| Author: | zammit [ Thu Dec 08, 2011 8:34 am ] |
| Post subject: | Re: Panhard rod length |
Nah I'll make it out of some chromemolly boiler tube! Anyone got lengths for me? |
|
| Author: | zooky08 [ Thu Dec 08, 2011 9:05 am ] |
| Post subject: | Re: Panhard rod length |
I have two here I assume the smaller one is the front and the longer one is rear. The front is 790mm, Rear is 925mm I would just go buy a td adjustable one. |
|
| Author: | zammit [ Thu Dec 08, 2011 9:33 am ] |
| Post subject: | Re: Panhard rod length |
I'm waiting for Jimny bits to get stock of there adjustables them I will buy a three in kit |
|
| Author: | zooky08 [ Thu Dec 08, 2011 9:42 am ] |
| Post subject: | Re: Panhard rod length |
The time you buy jb panhards it will be much more then td ones. I'm not sure what the difference in strength between the td ones and jb but I know that td panhards a very solid and look really strong. Measurements are roughly from center of eye to eye |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|