auszookers.com
https://auszookers.com/forum/

Anyone have a ProComp steering damper fitted to their Jimny?
https://auszookers.com/forum/viewtopic.php?f=5&t=28548		 Page 1 of 1
Author:  Liljim [ Mon Dec 12, 2011 4:23 am ]
Post subject:  Anyone have a ProComp steering damper fitted to their Jimny?
Hi, I just got this...

http://www.jimnybits.co.uk/shop/jimny/j ... d_115.html



Not too sure what a few of the brackets are for, and it has no instructions.

If anyone has one fitted can someone put up a pic, or explain where those rectangular brackets go?

Cheers.
Author:  steak_knife [ Mon Dec 12, 2011 5:19 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Ji
Run there shock's before, they did their job well...
Author:  Benz [ Mon Dec 12, 2011 6:03 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Jimny?
nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it
Author:  steak_knife [ Mon Dec 12, 2011 6:28 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Jimny?
Benz wrote:
nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it


Tis fitted wrong, will interfere with the drag link on r/h compression..
Should be chassis mounted further forward....
Author:  Liljim [ Mon Dec 12, 2011 6:36 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Jimny?
Think I've worked it out!
The rectangular steel plates bolt around the chassis rail, took me a few goes but it looks right, and doesn't foul on lock either direction.

Still wouldn't mind seeing pic from someone on here to make sure though, that pic does look it will foul when it goes full lock, can't quite see what it's bolted to.
Author:  Benz [ Mon Dec 12, 2011 6:39 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Jimny?
steak_knife wrote:
Benz wrote:
nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it


Tis fitted wrong, will interfere with the drag link on r/h compression..
Should be chassis mounted further forward....


haha well there you go.
Author:  steak_knife [ Mon Dec 12, 2011 7:35 am ]
Post subject:  Re: Anyone have a ProComp steering damper fitted to their Jimny?
Liljim wrote:
Think I've worked it out!
The rectangular steel plates bolt around the chassis rail, took me a few goes but it looks right, and doesn't foul on lock either direction.

Still wouldn't mind seeing pic from someone on here to make sure though, that pic does look it will foul when it goes full lock, can't quite see what it's bolted to.


you set that on fitting up..... :D
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/