| auszookers.com https://auszookers.com/forum/ |
|
| transfer seal sizes https://auszookers.com/forum/viewtopic.php?f=5&t=28671 |
Page 1 of 1 |
| Author: | tanshi [ Fri Dec 16, 2011 12:35 am ] |
| Post subject: | transfer seal sizes |
Can any one tell me what size the seals are from a 1.3 WT transfer? i need to get some and dont really want to wait until i can get them in a kit from low range. |
|
| Author: | TZAR [ Fri Dec 16, 2011 2:39 am ] |
| Post subject: | Re: transfer seal sizes |
go to cbc they have a list of all the seals |
|
| Author: | weaves [ Fri Dec 16, 2011 3:55 am ] |
| Post subject: | Re: transfer seal sizes |
| Author: | BlueSuzy [ Fri Dec 16, 2011 3:58 am ] |
| Post subject: | Re: transfer seal sizes |
2x 38 60 8mmthk 1x 38 50 8mmthk Speedo insert gear seals: 1x pushes into a 16.2mm hole, seals on a 7.9mm shaft. So allow smaller hole and bigger outer for a nice seal. Unsure width, 5mm By the looks of it. Oring around speedo insert, must seal on 19mm shaft, o'ring is 1.9thk, but slot is 2.4mm wide. |
|
| Author: | BlueSuzy [ Mon Dec 19, 2011 3:20 am ] |
| Post subject: | Re: transfer seal sizes |
Would these seals be ok for sealing on a 39.9 shaft? Seems i have some Wt pattern flanges here, but sizes are different?? The jackshaft and front output flange is taller so you cant get the spline nut on.. By 11.6mm..would these be coily? Using a 88.5wt casebut originally use nt shafts... Looks like i need to machine these weirdo's to make a normal wt flange... |
|
| Author: | BlueSuzy [ Mon Dec 19, 2011 3:22 am ] |
| Post subject: | Re: transfer seal sizes |
the rear output fit straght on. Thought it felt bit tight in seal.. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|