auszookers.com
https://auszookers.com/forum/

cv swap failure.
https://auszookers.com/forum/viewtopic.php?f=5&t=28704		 Page 1 of 1
Author:  swifty_ano [ Sat Dec 17, 2011 6:39 am ]
Post subject:  cv swap failure.
So I killed my CV.

I didn't read the thread about the CV swap. So today I decided to bash my CV's apart when I realised I did this.

Image

Now I can't get the inner bearing set up out to put the clips in.

What on earth can I do ?
Author:  Buddies72 [ Sat Dec 17, 2011 10:19 am ]
Post subject:  Re: cv swap failure.
swifty_ano wrote:
So I killed my CV.

I didn't read the thread about the CV swap. So today I decided to bash my CV's apart when I realised I did this.

Now I can't get the inner bearing set up out to put the clips in.

What on earth can I do ?


Is that the inner CV you have the photo of? If so did you pull the snap-ring out of the cup first? I can't see from the photo if it's still in there. If the snap-ring is out, the whole thing should just slide out with the axle still attached.

If that's the outer CV then that's what it's supposed to do.
Author:  Buddies72 [ Sat Dec 17, 2011 10:25 am ]
Post subject:  Re: cv swap failure.
I think the snap ring is still visible here betweent the arrows? This needs to be pulled out before you try to pull the ball cage etc. out.

Image

It's basicly a piece of spring steel wire that sits in the groove, you should be able to find an end to make it easier to pull it out.
Author:  swifty_ano [ Sun Dec 18, 2011 1:04 am ]
Post subject:  Re: cv swap failure.
Buddies. You have eyes of a god. I looked for hours and couldnt see any clips. Untill you pointed it out.
Helps if you know what to look for and when things aren't covered in grease.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/