| auszookers.com https://auszookers.com/forum/ |
|
| vitara coil wiring question https://auszookers.com/forum/viewtopic.php?f=5&t=28720 |
Page 1 of 1 |
| Author: | brando93 [ Sat Dec 17, 2011 10:29 pm ] |
| Post subject: | vitara coil wiring question |
In the process of a carby to EFI conversion of an 89 Vitara. Went to connect up the coil and connected to the bolt is this black square thing with two wires coming off it. Both wires are black with no markings but the two it connects to from the loom are black, but one has a white line. What is this thing? And is it polarity sensitive, if so, which wire goes where? Thanks 
|
|
| Author: | want33s [ Sat Dec 17, 2011 10:31 pm ] |
| Post subject: | Re: vitara coil wiring question |
Radio suppressor I think. If both wires are black then it doesn't matter which way you connect them. |
|
| Author: | steak_knife [ Sat Dec 17, 2011 10:45 pm ] |
| Post subject: | Re: vitara coil wiring question |
want33s wrote: Radio suppressor I think.
If both wires are black then it doesn't matter which way you connect them. Correct in a way, it's used to keep the coil quite so the ecu can't hear it.... That lil black thing with the white plug..... don't lose that.... 
|
|
| Author: | brando93 [ Sun Dec 18, 2011 3:41 am ] |
| Post subject: | Re: vitara coil wiring question |
Cheers, so its not polarity sensitive though? |
|
| Author: | steak_knife [ Sun Dec 18, 2011 3:49 am ] |
| Post subject: | Re: vitara coil wiring question |
brando93 wrote: Cheers, so its not polarity sensitive though?
No, if it was the wire's would be marked ( colored) Black with white stripe is ing, I think the other side goes into the neg of dizzy pulse... Just plug it in mate.... 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|