auszookers.com
https://auszookers.com/forum/

what have i done?
https://auszookers.com/forum/viewtopic.php?f=5&t=28865		 Page 1 of 2
Author:  swifty_ano [ Wed Dec 21, 2011 5:55 pm ]
Post subject:  what have i done?
Put my GV steel diff in last night. All looks the goods but when you try and drive it, its death.

Basically the car deicides to turn to the leftt. Once it starts turning that way you can get it back. It just fights against you. However, for a split second its fine.
Put the locker in and both wheels seem to engage.


There is also a rotational thump when your driving straight or turning.

My guess is CV as it doesn't seem like its sitting in the diff properly. Atari said there are issues with CV's popping out as they are about 5mm too long for the circlip to lock in.however this is doing it in 2wd and 4wd.

I need my car back ASAP :(
Author:  christover1 [ Wed Dec 21, 2011 7:52 pm ]
Post subject:  Re: what have i done?
Did you fit the GV axle support bush in correctly?
That could drag and thump, if its in wrong.
Author:  Brett [ Wed Dec 21, 2011 7:55 pm ]
Post subject:  Re: what have i done?
You driving it on the road or dirt with the hub locks in?
Author:  christover1 [ Wed Dec 21, 2011 7:55 pm ]
Post subject:  Re: what have i done?
Author:  christover1 [ Wed Dec 21, 2011 7:58 pm ]
Post subject:  Re: what have i done?
PS. My support bush was a bit squeaky and grabby till it bedded in.

And my locker took time to free up and bed in, too
Author:  swifty_ano [ Wed Dec 21, 2011 10:22 pm ]
Post subject:  Re: what have i done?
It's driven on dirt with both hubs locked and unlocked. Locker unlocked aswell.
I have to really fight it to turn right. But sometimes it does it fine.

Bush went in from the outside like you said chris so its all good.

CV slides all the way into the diff. It's like the outer CV is locking up
Author:  Brett [ Wed Dec 21, 2011 10:56 pm ]
Post subject:  Re: what have i done?
Sounds like your its your just your locker or your diff has been set up wrong
Author:  atari4x4 [ Wed Dec 21, 2011 10:57 pm ]
Post subject:  Re: what have i done?
did you check the diff ratio before sending it all off to be built?
Author:  swifty_ano [ Thu Dec 22, 2011 12:53 am ]
Post subject:  Re: what have i done?
But the thing is its playing up without hubs locked. It's on dry steer too. Not just whilst driving. It feels kind of like when I had a broken CV that was affecting ny steering but 50 times worse
Author:  atari4x4 [ Thu Dec 22, 2011 12:59 am ]
Post subject:  Re: what have i done?
bent steering/idler arm bracket
Author:  ninjamoses [ Thu Dec 22, 2011 1:09 am ]
Post subject:  Re: what have i done?
Your hubs definitely unlocking properly? Seems bloody strange for those kind of symptoms to happen without the hubs locked in.
Author:  Brett [ Thu Dec 22, 2011 2:00 am ]
Post subject:  Re: what have i done?
atari4x4 wrote:
did you check the diff ratio before sending it all off to be built?


Can't be that stupid hopefully
Author:  swifty_ano [ Thu Dec 22, 2011 3:51 am ]
Post subject:  Re: what have i done?
Ok. No I have stopped sooking. I took it for a decent drive.

Works fine with hubs unlocked. Works fine with hubs locked. But with locker in its a shit storm. I heard front lockers ruin your steering but this seems crazy

Mind you this was tested on road.

Sorry for bot testing properly.
Author:  atari4x4 [ Thu Dec 22, 2011 3:56 am ]
Post subject:  Re: what have i done?
so you're driving around in 4wd with the locker in on the tarmac? :crazy:

yes the front locker will make it hard to steer
Author:  swifty_ano [ Thu Dec 22, 2011 3:58 am ]
Post subject:  Re: what have i done?
Only 2wd with hubs locked
Author:  swifty_ano [ Thu Dec 22, 2011 3:58 am ]
Post subject:  Re: what have i done?
But egoism it be crazy hard and try and pull straight?
Author:  atari4x4 [ Thu Dec 22, 2011 4:00 am ]
Post subject:  Re: what have i done?
swifty_ano wrote:
But egoism it be crazy hard and try and pull straight?


WTF is egoism :lol: :helloo:
Author:  atari4x4 [ Thu Dec 22, 2011 4:01 am ]
Post subject:  Re: what have i done?
swifty_ano wrote:
Only 2wd with hubs locked


is that WITH the locker engaged?

if yes, it will behave like a welded diff.
Author:  swifty_ano [ Thu Dec 22, 2011 4:07 am ]
Post subject:  Re: what have i done?
atari4x4 wrote:
swifty_ano wrote:
Only 2wd with hubs locked


is that WITH the locker engaged?

if yes, it will behave like a welded diff.


Yes. This is true

Mind my ignorance. I am new to 4wd and have no idea about them
Author:  atari4x4 [ Thu Dec 22, 2011 4:10 am ]
Post subject:  Re: what have i done?
swifty_ano wrote:
atari4x4 wrote:
swifty_ano wrote:
Only 2wd with hubs locked


is that WITH the locker engaged?

if yes, it will behave like a welded diff.


Yes. This is true

Mind my ignorance. I am new to 4wd and have no idea about them


sounds like it's functioning as per normal, i only use mine when i know i'll be lifting the front wheels.

now can you tell me what "egoism" is.
Author:  swifty_ano [ Thu Dec 22, 2011 8:09 am ]
Post subject:  Re: what have i done?
Egoism is the result of a noob being frustrated and speed typing trying to figure out his car.
Author:  atari4x4 [ Thu Dec 22, 2011 8:11 am ]
Post subject:  Re: what have i done?
hehehe, what was it you were trying to type...
Author:  royce [ Thu Dec 22, 2011 8:13 am ]
Post subject:  Re: what have i done?
check your tyre pressures
Author:  swifty_ano [ Thu Dec 22, 2011 9:40 am ]
Post subject:  Re: what have i done?
atari4x4 wrote:
hehehe, what was it you were trying to type...


No idea :roll:
Author:  Built4thrashing [ Thu Dec 22, 2011 8:19 pm ]
Post subject:  Re: what have i done?
From what you have described is just how a GV/Vit handels when the front diff is locked. Just get over it and enjoy the added ability of having a front locker.
Author:  swifty_ano [ Fri Dec 23, 2011 1:14 am ]
Post subject:  Re: what have i done?
Built4thrashing wrote:
From what you have described is just how a GV/Vit handels when the front diff is locked. Just get over it and enjoy the added ability of having a front locker.


Phewww! The hole point of this thread was because i for my car out of the shed. Had been playing with the locker not realising id left it on and had a panic attack because it wouldn't steer.

Being new. To 4x4ing, I had no idea about lockers :(

She drives ok except when I turn left it sounds like my disc brakes are rubbing? Fine when o turn right
Author:  shandy92 [ Fri Dec 23, 2011 6:47 am ]
Post subject:  Re: what have i done?
swifty_ano wrote:
She drives ok except when I turn left it sounds like my disc brakes are rubbing? Fine when o turn right


wheel bearings!.....maybe u would check for play.

p.s why did you go front locker? or was it only done because the diff was out anyways?
Author:  swifty_ano [ Fri Dec 23, 2011 6:50 am ]
Post subject:  Re: what have i done?
shandy92 wrote:
swifty_ano wrote:
She drives ok except when I turn left it sounds like my disc brakes are rubbing? Fine when o turn right


wheel bearings!.....maybe u would check for play.

p.s why did you go front locker? or was it only done because the diff was out anyways?


Diff was out and needed to be pulled apart anyway. so I got it done at the same time.


With the wheel bearing lock nut thingo (ring with holes in it) is it possible that I have over tightened it.

It was fine before I pulled it apart.
Author:  shandy92 [ Fri Dec 23, 2011 8:05 am ]
Post subject:  Re: what have i done?
swifty_ano wrote:
shandy92 wrote:
swifty_ano wrote:
She drives ok except when I turn left it sounds like my disc brakes are rubbing? Fine when o turn right


wheel bearings!.....maybe u would check for play.

p.s why did you go front locker? or was it only done because the diff was out anyways?


Diff was out and needed to be pulled apart anyway. so I got it done at the same time.


With the wheel bearing lock nut thingo (ring with holes in it) is it possible that I have over tightened it.

It was fine before I pulled it apart.


not that i am aware of, but i could be wrong. when i did mine i did them as tight as i could but i was using the punch and hammer method :D
Author:  swifty_ano [ Sat Dec 24, 2011 1:52 am ]
Post subject:  Re: what have i done?
shandy92 wrote:
swifty_ano wrote:
shandy92 wrote:
swifty_ano wrote:
She drives ok except when I turn left it sounds like my disc brakes are rubbing? Fine when o turn right


wheel bearings!.....maybe u would check for play.

p.s why did you go front locker? or was it only done because the diff was out anyways?


Diff was out and needed to be pulled apart anyway. so I got it done at the same time.


With the wheel bearing lock nut thingo (ring with holes in it) is it possible that I have over tightened it.

It was fine before I pulled it apart.


not that i am aware of, but i could be wrong. when i did mine i did them as tight as i could but i was using the punch and hammer method :D



Turns out I didn't tighten them up. Note to self, don't rush things as you forget things lol
Page 1 of 2 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/