| auszookers.com https://auszookers.com/forum/ |
|
| What temp!!!!!!!! https://auszookers.com/forum/viewtopic.php?f=5&t=28880 |
Page 1 of 1 |
| Author: | sogone [ Thu Dec 22, 2011 6:15 am ] |
| Post subject: | What temp!!!!!!!! |
What temp does the baleno coil pack motor radiator fan switch on???? Trying to sort out my Sierra Baleno conversion. I'm gonna assume that vittie coil pack engines switch same temp. I have had it up to 105 Celsius proper on a mercury gauge. |
|
| Author: | royce [ Thu Dec 22, 2011 6:47 am ] |
| Post subject: | Re: What temp!!!!!!!! |
hang on, do you have a baleno coil pack engine or Vitara one? did the 1.6 GV have an engine driven fan? Did you find a manual and look and see what it says? |
|
| Author: | sogone [ Thu Dec 22, 2011 7:13 am ] |
| Post subject: | Re: What temp!!!!!!!! |
Can anyone tell me what ohms the baleno coil pack motor switches? For the thermal fan to work? I have a mpfi cool pack baleno motor. No manuals. No way to access Manuals easily. |
|
| Author: | steak_knife [ Thu Dec 22, 2011 8:09 am ] |
| Post subject: | Re: What temp!!!!!!!! |
I've just looked through my lil manual, all it say's is " cooling fan is switched on at "a" temp.... Doesn't say what..... & that's a Suzuki manual... |
|
| Author: | losfer [ Thu Dec 22, 2011 9:26 am ] |
| Post subject: | Re: What temp!!!!!!!! |
here you go .. |
|
| Author: | losfer [ Thu Dec 22, 2011 9:35 am ] |
| Post subject: | Re: What temp!!!!!!!! |
resistance check..... fixed |
|
| Author: | royce [ Thu Dec 22, 2011 9:58 am ] |
| Post subject: | Re: What temp!!!!!!!! |
IAT is air temp isnt it? anyway, if they are lower resistance for higher temp, unplug the sensor and (assuming it has 2 wires to it) bridge them and see if the fan comes on, if they run higher resistance at higher temp just unplug it and see if the fan comes on, if not check your wiring into the ecu |
|
| Author: | sogone [ Thu Dec 22, 2011 11:05 am ] |
| Post subject: | Re: What temp!!!!!!!! |
It's a three plug. If ya unplug it, the fan turns on. |
|
| Author: | sogone [ Fri Dec 23, 2011 6:16 am ] |
| Post subject: | Re: What temp!!!!!!!! |
The sensor is shagged. When it gets hot it's not sending signal back to Ecu. My tricky mate used the magic testie multimeter to work it out |
|
| Author: | steak_knife [ Fri Dec 23, 2011 6:23 am ] |
| Post subject: | Re: What temp!!!!!!!! |
sogone wrote: It's a three plug. If ya unplug it, the fan turns on. sogone wrote: The sensor is shagged. When it gets hot it's not sending signal back to Ecu. My tricky mate used the magic testie multimeter to work it out
You already had it, but some people just cant think for em self's... Sorry mate, but I don't like just handing out answer's, gotta make you guy's start thinking for your self's...
|
|
| Author: | sogone [ Fri Dec 23, 2011 7:22 am ] |
| Post subject: | Re: What temp!!!!!!!! |
Explain this to me stekky. Even if it was cold ya unplug it and the fan turns on. How do you mean I already had the answer. I like learnings |
|
| Author: | royce [ Fri Dec 23, 2011 7:25 am ] |
| Post subject: | Re: What temp!!!!!!!! |
the ecu wants to see a certain amount of resistance to earth or higher to switch the fan on when you unplug the sensor then its infinite resistance which in this case will be higher than its mark so turns on, its also somewhat of a failsafe for broken wires or unplugged sensors |
|
| Author: | sogone [ Fri Dec 23, 2011 7:31 am ] |
| Post subject: | Re: What temp!!!!!!!! |
Ha. I didn't even think of that. Thanks Royce! |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|