[brando93]

Converting an 89 SWB vit to EFI, donor is a 94 LWB vit, used the engine and loom.

There is a cable coming from the extractor in the exhaust, has a thin spade bit. Was already disconnected when i got the donor car. Can anyone tell me where it joins to? can't seem to find anything anywhere near it.

thanks in advance
Brandon

[christover1]

Mines a 93 LWB EFI.

It joins on to a plug on firewall, in line with it.

I'll take a photo in a few minutes

[christover1]

Near bottom right of coil

[brando93]

myne appears to be similar but only one single black cable? as shown in the picture.
any idea how it will go?
in your pic it looks like it only has one black cable at the bottom, but the plug is four pin and has four cables at the top??

[christover1]

Mine is only one black wire.
Not sure why it has a 4 pin plug.
No idea if other wires have any purpose.

Black to black would be my guess, if you have that choice

You need to get more expert opinion,
but I reckon it will work...hopefully

[christover1]

I'll go out and see if I can see color it plugs too brb

[Bruce]

Fuck your a good AZ member christover1
oppss more rum

[christover1]

3 pins are blanks. o2 wire plugs to a red with purple stripe...its a bit dark, but think I could see that

[christover1]

Bruce wrote:

Fuck your a good AZ member christover1
oppss more rum

AZ gives back too

[Bruce]

christover1 wrote:

Bruce wrote:

Fuck your a good AZ member christover1
oppss more rum

AZ gives back too

WHen ya not a dick like some

[brando93]

Thanks bud, will give it a go tommorrow appreciate the help!