auszookers.com
https://auszookers.com/forum/

Vit clutch won't spring back
https://auszookers.com/forum/viewtopic.php?f=5&t=29000		 Page 1 of 1
Author:  brando93 [ Tue Dec 27, 2011 1:53 am ]
Post subject:  Vit clutch won't spring back
Hey guys, ive just done an engine conversion to a swb vit, leaving the same gearbox in. Ive gone to reconnect the clutch cable and now it wont spring back.
If i manually push and pull the arm by the gearbox, the cable moves in and out and the spline rotates a little bit, but stays at either fully in or out.
If i manually push the pedal it moves the spline and cable but stays in, if i pull the pedal out, the spline and cable move back.
Cant yet start the car to see if its engaging.
Basically the clutch just doesnt spring back, any idea whats wrong? Spring up under the dash on clutch pedal seems to be okay??
Probably something straight forward but its got me stuck :s
Thanks in advance :)
Author:  brando93 [ Tue Dec 27, 2011 11:49 am ]
Post subject:  Re: Vit clutch won't spring back
anyone have any idea? kinda urgent
Author:  steak_knife [ Tue Dec 27, 2011 12:41 pm ]
Post subject:  Re: Vit clutch won't spring back
Adjustment by the sound's of it, screw the nut on the cable up a bit & see if it change's.....
Author:  CairnsZook [ Tue Dec 27, 2011 9:06 pm ]
Post subject:  Re: Vit clutch won't spring back
Is it the same set-up as a Sierra box?
Image

While the box was out, did you take the clutch release bearing off the input shaft? Or fiddle with the spring on the clutch release shaft?
If the spring isn't sitting right, or is broken, it would cause the symptoms you describe.
Author:  brando93 [ Wed Dec 28, 2011 2:28 am ]
Post subject:  Re: Vit clutch won't spring back
looks very similar.. we did swap the clutch over so may of not gona back together properly :s
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/