| auszookers.com https://auszookers.com/forum/ |
|
| lj50 first start https://auszookers.com/forum/viewtopic.php?f=5&t=29148 |
Page 1 of 1 |
| Author: | Llewellyn92 [ Sun Jan 01, 2012 3:01 am ] |
| Post subject: | lj50 first start |
Gday guys, just picked up an old lj50 |
|
| Author: | MrRocky [ Sun Jan 01, 2012 3:36 am ] |
| Post subject: | Re: lj50 first start |
bahhh just run premix and kick it in the guts clean the plugs too |
|
| Author: | Llewellyn92 [ Sun Jan 01, 2012 4:07 am ] |
| Post subject: | Re: lj50 first start |
what ratio? |
|
| Author: | Daves4wd [ Sun Jan 01, 2012 4:44 am ] |
| Post subject: | Re: lj50 first start |
Isn't it a self mixing system?? If not run a 50-1 something like that only thing is I'm used to running small 2strke engines witch are 25-1 |
|
| Author: | TZAR [ Sun Jan 01, 2012 7:31 am ] |
| Post subject: | Re: lj50 first start |
fogging oil. Its a lubricant and fuel in one designed for two stroke engines PLUGS OUT and crank it over after spraying heaps down the carby and some down the spark plug holes. Then plugs in and spray down the carby until the bowl fills up. |
|
| Author: | 3cyl [ Sun Jan 01, 2012 7:34 am ] |
| Post subject: | Re: lj50 first start |
Clean out the oil tank and lines, also check it has the right plugs, NGK B7HS. It won't hurt to run premix, out of a mower tin or something but once the oil is bled through into the motor it'll foul the plugs pretty quickly. Also once it's idling you can hold the oil pump control lever on full to get any air bubbles out of the lines. Maybe drain any old fuel or crap out of the tank too. |
|
| Author: | Llewellyn92 [ Thu Jan 05, 2012 10:48 pm ] |
| Post subject: | Re: lj50 first start |
what oil do u guys run anyway? |
|
| Author: | MrRocky [ Sat Jan 07, 2012 2:58 am ] |
| Post subject: | Re: lj50 first start |
bike oil, small engine oil, tried a few 2stoke oils now and seems the happiest on mower oil |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|