I used this one. It was a few yeras ago, but I don't remember it costing that much though
http://www.ebay.com.au/itm/H-DUTY-CLUTC ... 256b0c995d
| auszookers.com https://auszookers.com/forum/ |
|
| 1.3 clutch https://auszookers.com/forum/viewtopic.php?f=5&t=29233 |
Page 1 of 1 |
| Author: | adamp493 [ Tue Jan 03, 2012 11:14 pm ] |
| Post subject: | 1.3 clutch |
are all clutches in the 1.3 the same? only asking because i have an sj80 and i am after a new one any help would be awesome |
|
| Author: | Scrawny [ Tue Jan 03, 2012 11:34 pm ] |
| Post subject: | Re: 1.3 clutch |
Just order one for an SJ80? I believe there's two different ones, different flywheels (stepped vs flat). Exedy lists a SZK6474 - Size, Spline OD & No. of Teeth 190 x 22.4 x 20 There is also a SZK6288 (SJ50/51) - Size, Spline OD & No. of Teeth 190 x 22.4 x 20 |
|
| Author: | bagnkat [ Tue Jan 03, 2012 11:52 pm ] |
| Post subject: | Re: 1.3 clutch |
I used this one. It was a few yeras ago, but I don't remember it costing that much though
http://www.ebay.com.au/itm/H-DUTY-CLUTC ... 256b0c995d |
|
| Author: | boostedbrick [ Tue Jan 03, 2012 11:53 pm ] |
| Post subject: | Re: 1.3 clutch |
Scrawn wrote: Just order one for an SJ80? I believe there's two different ones, different flywheels (stepped vs flat).
Exedy lists a SZK6474 - Size, Spline OD & No. of Teeth 190 x 22.4 x 20 There is also a SZK6288 (SJ50/51) - Size, Spline OD & No. of Teeth 190 x 22.4 x 20 SZK-6293 is the flat flywheel exedy.. |
|
| Author: | adamp493 [ Wed Jan 04, 2012 12:58 am ] |
| Post subject: | Re: 1.3 clutch |
cool thanks for the help |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|