auszookers.com
https://auszookers.com/forum/

Flywheel Bolts
https://auszookers.com/forum/viewtopic.php?f=5&t=29302		 Page 1 of 1
Author:  rwt65 [ Thu Jan 05, 2012 9:53 pm ]
Post subject:  Flywheel Bolts
I am after the specs for flywheel bolts, what thread size and diameter?
Do they vary from model to model?
Want to get new replacements, what do I need to get?
Cheers
Richard T
Author:  squibby [ Thu Jan 05, 2012 10:13 pm ]
Post subject:  Re: Flywheel Bolts
Stretch bolts probably. We should buy new ones when we replace them, probably best to get them from the dealer since they are a specialised item imo. That said I have been naughty and re-used them myself with no explosions as yet, although I'd definately buy new ones the second time they are undone. You'll need eight of them on a M-series engine.
Author:  rwt65 [ Thu Jan 05, 2012 10:40 pm ]
Post subject:  Re: Flywheel Bolts
:oops: , sorry about that, G13 series engine and details?
Author:  want33s [ Thu Jan 05, 2012 10:49 pm ]
Post subject:  Re: Flywheel Bolts
squibby wrote:
Stretch bolts probably. .................................................

No they aren't.
They are fine to reuse if they aren't damaged.

You can pick a single use bolt by the torque settings in the FSM.
Normal reusable bolts just have a set torque rating to tighten to.. EG 40Nm

Single use bolts will be EG 40Nm plus a quarter turn.
Author:  squibby [ Thu Jan 05, 2012 11:00 pm ]
Post subject:  Re: Flywheel Bolts
want33s wrote:
No they aren't.

oh good
Author:  Rhinoman [ Fri Jan 06, 2012 9:12 pm ]
Post subject:  Re: Flywheel Bolts
Use threadlock when you replace them, they have a habit of falling out if you don't.
Author:  whincup [ Fri Jan 06, 2012 11:57 pm ]
Post subject:  Re: Flywheel Bolts
Rhinoman wrote:
Use threadlock when you replace them, they have a habit of falling out if you don't.


x2 :oops:

http://www.auszookers.com/index.php?nam ... 07&start=0
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/