Measure the width of your rim...
Measure the backspacing...
Subtract the backspace from half of the width gives offset*...
*May or may not be correct... I've had a few..
| auszookers.com https://auszookers.com/forum/ |
|
| offset question https://auszookers.com/forum/viewtopic.php?f=5&t=29424 |
Page 1 of 1 |
| Author: | thesupervisor [ Mon Jan 09, 2012 9:36 am ] |
| Post subject: | offset question |
ive got 16 wheels and 1 inch spacers on my gv it now sits on the tracks better and looks better but time for new rims if i was ordering rims what would offset would i need? i need ? any one got good shops to deal with in the us? |
|
| Author: | Shansh [ Mon Jan 09, 2012 9:39 am ] |
| Post subject: | Re: offset question |
if you wanted the same result from rims only with no spacers, wouldnt it be whatever the offset is of your current rims with an additional 25 mm of negative offset? i.e. if they are -13, then the new rims would need to be -38 hope this helps |
|
| Author: | thesupervisor [ Mon Jan 09, 2012 9:43 am ] |
| Post subject: | Re: offset question |
not sure what the stock ones are but if thats correct -40 would be ok i prefer round numbers and i could still go another 10mm past the guards |
|
| Author: | matty_wall [ Mon Jan 09, 2012 9:58 am ] |
| Post subject: | Re: offset question |
Fairly sure GVs came out with a variety of offsets. all of them positive. i'd take a guess that your either on 0 offset at the moment or slightly neg. maybe -5ish with the spacers. |
|
| Author: | want33s [ Mon Jan 09, 2012 10:21 am ] |
| Post subject: | Re: offset question |
Measure the width of your rim...
Measure the backspacing...
Subtract the backspace from half of the width gives offset*... *May or may not be correct... I've had a few.. |
|
| Author: | atari4x4 [ Mon Jan 09, 2012 10:24 am ] |
| Post subject: | Re: offset question |
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|