auszookers.com
https://auszookers.com/forum/

Torque setting for a g16b flywheel
https://auszookers.com/forum/viewtopic.php?f=5&t=29491		 Page 1 of 1
Author:  Ratty562 [ Thu Jan 12, 2012 5:21 am ]
Post subject:  Torque setting for a g16b flywheel
Hi all

I'm after the torque setting for the flywheel g16b out of a suzuki baleno

Thanks matt
Author:  Boneheimer [ Thu Jan 12, 2012 5:23 am ]
Post subject:  Re: Torque setting for a g16b flywheel
Vitara fsm says 78 N.m (7.8 kg-m, 56.5 lb-ft) for G16B, so I would assume the same, unless someone here says otherwise.
Author:  steak_knife [ Thu Jan 12, 2012 6:18 am ]
Post subject:  Re: Torque setting for a g16b flywheel
Spot on!!!! :helloo:

18-28nm for the pressure plate. :helloo:
Author:  Benchai [ Thu Jan 12, 2012 6:22 am ]
Post subject:  Re: Torque setting for a g16b flywheel
steak_knife wrote:
Spot on!!!! :helloo:

18-28nm for the pressure plate. :helloo:

I thought you'd tighten till the thread strips then back it off a quarter turn Stekkie :twisted:
Author:  Ratty562 [ Thu Jan 12, 2012 6:28 am ]
Post subject:  Re: Torque setting for a g16b flywheel
Thanks guys :)
Author:  steak_knife [ Thu Jan 12, 2012 7:20 am ]
Post subject:  Re: Torque setting for a g16b flywheel
Benchai wrote:
steak_knife wrote:
Spot on!!!! :helloo:

18-28nm for the pressure plate. :helloo:

I thought you'd tighten till the thread strips then back it off a quarter turn Stekkie :twisted:


:roll: 1/2 a turn mate, don't want em to tight.... :roll:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/