Hi all,
well i just finished installing my new clutch fan on my g16b vitara, i thought some of the people might find it helpful.
i bought this from suzistore for $165 and its a full flow brand.
first things first disconnet the neg on the battery, then you need to remove the 4 bolts that hold in the fan shroud. 1 in each corner.
then the 4 bolts that hold the fan on can be removed.
then carefully remove the shroud and fan together with out damaging the radiator. you will then have this below
carefully remove the 4 mounting bolts, they can be tight so dont use the blades to push against, they will break.
at this point, inspect the fan for any cracks or damage and replace, you can then fit the fan to the cluch and tighten
i also replaced my fan belt, but install is the same as remove.
while the shroud is out it is a good idea to get the hose against the rad to clean out any crap that may be externally in the fin's. wash from the engine side out, i was amazed at how much crap came of it.
hope this helps someone, could be done in 30 mins. took me a bit longer as i cleaned rad and fitted belts.
