| auszookers.com https://auszookers.com/forum/ |
|
| help balino motor running rich https://auszookers.com/forum/viewtopic.php?f=5&t=30044 |
Page 1 of 1 |
| Author: | =wardy= [ Tue Jan 31, 2012 1:35 pm ] |
| Post subject: | help balino motor running rich |
as above,i didnt install the motor and it has always run rich, changed all the basics but it is still the same,can someone give me advice |
|
| Author: | Boneheimer [ Tue Jan 31, 2012 1:46 pm ] |
| Post subject: | Re: help balino motor running rich |
Is this a transplant into a sierra? |
|
| Author: | =wardy= [ Tue Jan 31, 2012 2:10 pm ] |
| Post subject: | Re: help balino motor running rich |
Boneheimer wrote: Is this a transplant into a sierra? yep |
|
| Author: | royce [ Tue Jan 31, 2012 2:24 pm ] |
| Post subject: | Re: help balino motor running rich |
When does it run rich and how have you determined it is rich? |
|
| Author: | =wardy= [ Tue Jan 31, 2012 2:30 pm ] |
| Post subject: | Re: help balino motor running rich |
royce wrote: When does it run rich and how have you determined it is rich? only notice it when taking off or at idle plenty of black smoke mechenic has looked at it cant find any problems ,he seems to think its a computer problem |
|
| Author: | Boneheimer [ Tue Jan 31, 2012 2:31 pm ] |
| Post subject: | Re: help balino motor running rich |
Have you installed the VSS and O2 sensor? I'm pretty sure that without these the ECU will run the engine in lean conditions in order to keep it running. I thought black smoke was burning oil? |
|
| Author: | =wardy= [ Tue Jan 31, 2012 2:39 pm ] |
| Post subject: | Re: help balino motor running rich |
Boneheimer wrote: Have you installed the VSS and O2 sensor? I'm pretty sure that without these the ECU will run the engine in lean conditions in order to keep it running. I thought black smoke was burning oil? i had a vitara motor and it had a air flow meter which this motor hasnt got dont no about vss or 02 sensor where do they go blue smoke is burning oil |
|
| Author: | Boneheimer [ Tue Jan 31, 2012 2:56 pm ] |
| Post subject: | Re: help balino motor running rich |
Not 100% on the baleno engine, but if it's like the vitara engine and came with one stock it should be on your exhaust manifold (if its OBDII there will be one on your cat converter as well). The VSS is a vehicle speed sensor, which you should be able to read up on, I'm no expert, but from what I know it backs off the fuel when the engine isn't under load. Here's a link with some info, there's also more in good tech I think. [http://auszookers.com/forum/viewtopic.php?f=14&t=9978] This makes the most sense to me, if it's blowing smoke when you're at idle, or after you've been at idle. Hopefully someone else knows a bit more about this. |
|
| Author: | royce [ Tue Jan 31, 2012 3:05 pm ] |
| Post subject: | Re: help balino motor running rich |
What is it using as the fuel return line? Been a few threads about conversions where people use the stock fuel return and its too small, especially with bigger external pumps so the fuel pressure ends up too high when not a lot of fuel is being used which will make it run rich. Worth a look. |
|
| Author: | =wardy= [ Tue Jan 31, 2012 4:14 pm ] |
| Post subject: | Re: help balino motor running rich |
royce wrote: What is it using as the fuel return line? Been a few threads about conversions where people use the stock fuel return and its too small, especially with bigger external pumps so the fuel pressure ends up too high when not a lot of fuel is being used which will make it run rich. Worth a look. fuel return runs through standard line so will try that first and let u no |
|
| Author: | youda [ Tue Jan 31, 2012 4:16 pm ] |
| Post subject: | Re: help balino motor running rich |
check the fuel reg vac line dosent have a hole or crack in it |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|