i found a couple pin holes that go through the panel so i'm gonna have to get it fixed
| auszookers.com https://auszookers.com/forum/ |
|
| Sill repairs https://auszookers.com/forum/viewtopic.php?f=5&t=3023 |
Page 1 of 1 |
| Author: | Mike [ Fri Sep 26, 2008 6:34 pm ] |
| Post subject: | Sill repairs |
i've been fixing up the sills on my sierra and i cut of the bracket on the sills and there was a bit of surface rust underneath so i ground that back but now i'm left with a few spots where the rust has eaten into the metal a bit but i cant get into them to sand grind them what would be the best way to fix it so i can paint over it and not have to worry about it rusting anymore? Cheers |
|
| Author: | royce [ Fri Sep 26, 2008 6:47 pm ] |
| Post subject: | Re: Sill repairs |
rust convertor and paint over it |
|
| Author: | Mike [ Fri Sep 26, 2008 6:51 pm ] |
| Post subject: | Re: Sill repairs |
i've never been able to get that stuff to work its the only rust i've found in my whole zook and i want to do something with it so i don't have to worry about it again |
|
| Author: | royce [ Fri Sep 26, 2008 6:57 pm ] |
| Post subject: | Re: Sill repairs |
use the milky looking white night stuff, the other ones dont seem as good |
|
| Author: | 2stroker [ Fri Sep 26, 2008 7:12 pm ] |
| Post subject: | Re: Sill repairs |
I have had pretty good results from a Septone product called Rustprime. |
|
| Author: | Mike [ Fri Sep 26, 2008 7:17 pm ] |
| Post subject: | Re: Sill repairs |
i found a couple pin holes that go through the panel so i'm gonna have to get it fixed
|
|
| Author: | Damo [ Sat Sep 27, 2008 1:53 am ] |
| Post subject: | Re: Sill repairs |
I had similar problems, did the passenger's side but haven't done the driver's side yet. 
|
|
| Author: | Mike [ Sat Sep 27, 2008 2:00 am ] |
| Post subject: | Re: Sill repairs |
mine isn't that bad there are only 2 pin holes that have rusted through but i'm gonna have to get some one to fix it for me because i don't want to fuck the sill 
|
|
| Author: | jimbo_jones [ Tue Sep 30, 2008 2:03 am ] |
| Post subject: | Re: Sill repairs |
use a die grinder to clean up the small spots |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|