auszookers.com
https://auszookers.com/forum/

Replacing L/H Rear Axle Seal
https://auszookers.com/forum/viewtopic.php?f=5&t=30687		 Page 1 of 1
Author:  Total_Filth [ Thu Feb 23, 2012 1:41 pm ]
Post subject:  Replacing L/H Rear Axle Seal
Hey Fellas,

My rear Axle Seal is leaking pretty bad and I need to replace it. Can anyone give me some advice on the best way to do it or where I can read more information about it.

Also what tools and materials will I need. Cheers


TF
Author:  zukmeista [ Thu Feb 23, 2012 2:09 pm ]
Post subject:  Re: Replacing L/H Rear Axle Seal
You will need to replace the bearing at the same time. If one is leaking it is a good idea to do the other side at the same time 'cos it will start leaking about a week later :roll: You will need a grinder, a press and basic hand tools. :wink:
Author:  zooky08 [ Thu Feb 23, 2012 3:38 pm ]
Post subject:  Re: Replacing L/H Rear Axle Seal
Word of advice, don't use non geniune seals.
When I did my bearings a had a non genuine seal and a geniune seal.
You can guess what seal is fucked straight away after I put it in.
Author:  Joshyboy26 [ Thu Feb 23, 2012 4:59 pm ]
Post subject:  Re: Replacing L/H Rear Axle Seal
Look in the good tech bit I think it's in there
Author:  Daves4wd [ Thu Feb 23, 2012 5:33 pm ]
Post subject:  Re: Replacing L/H Rear Axle Seal
Basic spanner socket set chain or rope to pull out axel steel tube to press bearings on know how to bleed brakes grinder that's it from memory pretty easy once you do one side and clean the inside of your drums so it looks good until you hit mud hahaha
Author:  Total_Filth [ Fri Feb 24, 2012 8:20 am ]
Post subject:  Re: Replacing L/H Rear Axle Seal
Cheers blokes. Think i might let the mechanic do this one :(

Will ask if i can watch though! haha.


TF
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/