auszookers.com
https://auszookers.com/forum/

Shafted
https://auszookers.com/forum/viewtopic.php?f=5&t=31427		 Page 1 of 1
Author:  Bombero [ Sun Mar 25, 2012 5:27 am ]
Post subject:  Shafted
I have a mg410 Maruti (96 stockman) I need new drive shafts front and back because the slip joints are stuffed. I'm finding it hard to get a replacement. Will the nt Lwb ones fit? Or, is it possible to put new slip joints on? While I'm at it, if anyone has any to get rid of let me know.
Any help will be greatly appreciated. Thanks.
Author:  want33s [ Sun Mar 25, 2012 7:47 am ]
Post subject:  Re: Shafted
I have a few NT 1.3 front shafts here.
Not sure if they'll fit yours though.
Author:  Bombero [ Sun Mar 25, 2012 1:21 pm ]
Post subject:  Re: Shafted
Have they got good slip joints? If so do you think it's possible to get them cut of and welded on my shafts for a reasonable price?
Author:  want33s [ Sun Mar 25, 2012 1:37 pm ]
Post subject:  Re: Shafted
Bombero wrote:
Have they got good slip joints? If so do you think it's possible to get them cut of and welded on my shafts for a reasonable price?


Slip joints are fine.
Any shafting service place can replace the tube.


NT flange...
Image
Author:  Bombero [ Sun Mar 25, 2012 1:48 pm ]
Post subject:  Re: Shafted
If the flange is different I should be able to pop the uni and put my flanges on shouldn't I? Do they use the same uni? How much do you want for the shaft? Thanx for the quick reply
Author:  want33s [ Sun Mar 25, 2012 3:36 pm ]
Post subject:  Re: Shafted
As far as I know you can do a half half uni joint if they are different cap sizes.
Front NT shaft... $50 delivered.
Drop one of your shafts and measure the flange.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/