royce wrote:
about that
i didn't think it was quite that thick
| auszookers.com https://auszookers.com/forum/ |
|
| Thickness https://auszookers.com/forum/viewtopic.php?f=5&t=3170 |
Page 1 of 1 |
| Author: | Mike [ Thu Oct 16, 2008 1:40 am ] |
| Post subject: | Thickness |
does anyone know what the thickness of the body panels on a sierra is? Cheers |
|
| Author: | royce [ Thu Oct 16, 2008 1:43 am ] |
| Post subject: | Re: Thickness |
about that |
|
| Author: | Mike [ Thu Oct 16, 2008 1:44 am ] |
| Post subject: | Re: Thickness |
royce wrote: about that
i didn't think it was quite that thick
|
|
| Author: | Mike [ Thu Oct 16, 2008 1:58 am ] |
| Post subject: | Re: Thickness |
Mike wrote: royce wrote: about that i didn't think it was quite that thick but seriously how thick are sierra panels? |
|
| Author: | Cozook [ Thu Oct 16, 2008 2:09 am ] |
| Post subject: | Re: Thickness |
Repairing some body panels would require perhaps some 26 gage (.018) or 24 gage (.023) … easy to bend and form by hand. The front fender off my zuk measures about .035 or 20 gage. A gas tank or a flat panel that needs some strength makes 16 gage (.059) or 14 gage (.075) a better choice although some equipment might be needed to bend these heavier gages. I checked the deformed stock front bumper off my zuk and it measured about .065. ...... From izook.com(metalshop) |
|
| Author: | lump_a_charcoal [ Thu Oct 16, 2008 2:19 am ] |
| Post subject: | Re: Thickness |
I was gonna say Alfoil, but then I realised mine rusts. |
|
| Author: | Taff [ Thu Oct 16, 2008 2:23 am ] |
| Post subject: | Re: Thickness |
lump_a_charcoal wrote: I was gonna say Alfoil, but then I realised mine rusts.
Its not just contained to yours 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|