| auszookers.com https://auszookers.com/forum/ |
|
| modifying 323 GTX rotor for G13B https://auszookers.com/forum/viewtopic.php?f=5&t=3263 |
Page 1 of 1 |
| Author: | Chinny [ Tue Oct 28, 2008 11:59 pm ] |
| Post subject: | modifying 323 GTX rotor for G13B |
I've got the 323 gtx dist and rotor button. The dist cap is simple to fit. But how have people fitted the button onto the shaft? My get is to machine a spacer that will bolt/weld onto the existing shaft. I'd like some opinions or past experiences. I have a Mk3 Gti motor. 
Cheers |
|
| Author: | Chinny [ Mon Nov 10, 2008 1:01 am ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
my solution: brass spacer to fit in the rotor button that slides onto the gti dist shaft. cut the shaft down 4mm and drill n insert a roll pin. 
|
|
| Author: | Scrawny [ Mon Nov 10, 2008 3:18 am ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
Impressive work Chinny!! We may just have to kick you out of this forum though... you are putting us all to shame!! We usually just talk about doing stuff and then just keep putting it off, then talk some more!! With you it's all just results! And they are bloody impressive 
|
|
| Author: | Chinny [ Mon Nov 10, 2008 4:22 pm ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
thanks bud. I'll be impressed when i get to wheel it
|
|
| Author: | Damo [ Mon Nov 10, 2008 5:05 pm ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
ScrawnC wrote: Impressive work Chinny!!
We may just have to kick you out of this forum though... you are putting us all to shame!! We usually just talk about doing stuff and then just keep putting it off, then talk some more!! With you it's all just results! And they are bloody impressive Just wait til he has a house, missus and kids, then see how fast he gets things done 
|
|
| Author: | Pubic [ Mon Nov 10, 2008 11:31 pm ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
if thats all you need to fit the gti motor, i think you would have a pretty decent market there for anyone doing the same conversion. from what i have heard the adaptor angle drives you buy are big $! might be an idea to make a complete setup ready to install and sell them for a tidy little profit. |
|
| Author: | Chinny [ Wed Nov 12, 2008 12:20 am ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
Damo wrote: Just wait til he has a house, missus and kids, then see how fast he gets things done NEVER!!!! 
|
|
| Author: | canberramav [ Wed Jun 03, 2009 12:46 am ] |
| Post subject: | Re: modifying 323 GTX rotor for G13B |
Gday Ive used the bush out of the GTI dizzy rotor and fitted it to the distributer. I was wondering if you could check the clearance (distance) of the rotor button from the side of the distributer. Im trying to figure out if my rotor button is sitting to high or to low on the distributor shaft. Cheers |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|