| auszookers.com https://auszookers.com/forum/ |
|
| Transfer and gearbox breathers https://auszookers.com/forum/viewtopic.php?f=5&t=32693 |
Page 1 of 1 |
| Author: | Deego [ Thu May 17, 2012 7:03 pm ] |
| Post subject: | Transfer and gearbox breathers |
Has any one wrote information about how to install transfer and gearbox breathers |
|
| Author: | zooky08 [ Thu May 17, 2012 7:07 pm ] |
| Post subject: | Re: Transfer and gearbox breathers |
viewtopic.php?f=14&t=6031 |
|
| Author: | mrw82 [ Thu May 17, 2012 7:57 pm ] |
| Post subject: | Re: Transfer and gearbox breathers |
No, nobody has done it. If you could take pics as you do it and post up a bit of a write up that'd be great. |
|
| Author: | jonfromhamilton [ Fri May 18, 2012 7:57 pm ] |
| Post subject: | Re: Transfer and gearbox breathers |
I did my transfer case breather the other day it was piss easy. 1 x brass 0.25" BSP brass fitting little filter i got that usually goes on a lawnmower. the 0.187" fuel line I think is too thin it is too restricitive and I didn't want to pay for the 0.375" tube at $13/m so I am yet to source some hose. the factory breather just needs to be tapped which is super easy as the t-case is aluminium then I put some teflon tape (only a thin ammount) on the brass thread and soem aircraft glue ($4 per bottle at bursons) and voila. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|